Xyron Creatopia Border Patternz
This range of Xyron Creatopia Border Patternz provides everything you need to bring a fun touch to your creative projects. Perfect for paper or card stock, you can create unique holiday cards, party invitations and any other project that requires a creative approach. Choose from the amazing products listed below for the one you need. We carry the Border Patternz Starter Kit, as well as various embossing cartridges. Hearts, stars, animal paws, dots, or scallops – these are a few of the different styles you can use to make your projects stand out. Get more creative today and order your Xyron Creatopia supplies from MyBinding!
Using Xyron Patternz and Borderz Video
Transcript:
Remove pressure rollers or any other component from main unit and set aside. Load Patternz or Borderz by sliding into the component tracks until it clicks into place. Fold tray down and slide toward component. Align paper with right side of tray. Turn handle and guide paper through rollers with your hand. To unload embossing rollers, press component buttons and remove component. Remove end caps to take Borderz cartridge off bars. Line up bars so the flat side of the bars are facing each other. Line up Borderz cartridge as shown and slide onto bar with the dark gray borders on the bottom. Spin ...
Read More
Remove pressure rollers or any other component from main unit and set aside. Load Patternz or Borderz by sliding into the component tracks until it clicks into place. Fold tray down and slide toward component. Align paper with right side of tray. Turn handle and guide paper through rollers with your hand. To unload embossing rollers, press component buttons and remove component. Remove end caps to take Borderz cartridge off bars. Line up bars so the flat side of the bars are facing each other. Line up Borderz cartridge as shown and slide onto bar with the dark gray borders on the bottom. Spin bars to line up with end cap. Position end caps on bars and snap in place. Slide Borderz cartridge into end cap and snap in place. Load Borderz by sliding component into the component tracks until it clicks into place.
