Challenge False Clamp Plate for Titan 200 and 200BC Paper Cutters

Pair this false clamp plate with your Challenge Machinery Titan 200 paper cutter. It is an optional accessory that is used to prevent any marking on pressure-sensitive paperwork and jobs. This plate attaches to the bottom of the clamp and is secured with wing nuts on studs that pass through the top of the clamp. It is important to note that, with the Titan 200 false clamp installed, the minimum cut is affected, changing from 1/2" to 1.75". This part is OEM / manufacturer-direct from Challenge Machinery for perfect compatibility. Sold individually.

How to Install the Titan 200 Optional False Clamp Plate

1. Make sure the knife and clamp are in the up position. If they are not, turn on the power using the red and yellow main power switch, close the front guard, and press the CLEAR button. This will preset the back gauge and send the knife and clamp up.
2. Turn the power off and disconnect the power cord.
3. Open the front guard (if equipped) and slide the false clamp plate under the knife and clamp (Figure 13) and slide the plate up into position with the locator pins toward the front of the machine. The locator pins insert into holes in the bottom front of the clamp.
4. Hold the plate in position and secure with the wing nuts provided.
5. Change the false clamp setting of the machine to ON to prevent the backgauge from crashing into the false clamp plate. This is done in the Maintenance Mode/Parameters/False Clamp screen. For more details on how to do this, see page 24.