Logan XTD30 COS-Tools Knife
6.50
NewCondition
OutOfStock
We're sorry, but we no longer offer this item.
Call us at 1-800-944-4573 for personalized recommendations
or check out these similar items that may be a good fit:
Logan XTD30 COS-Tools Knife
SWIPE FOR MORE IMAGES
- 0
- 1
- 2
- 3
- 4
Product Description
Hand held adjustable depth utility knife with snap off blade and solid locking mechanism for consistent depth settings. Used to size suitable Cosplay materials. Must have scrap foamboard under material as underlayment. Uses replacement blade XTD-5.
Product Details
- Hand held adjustable depth utility knife.
- Snap off blade.
- Solid locking mechanism for consistent depth settings.
- Used to size suitable Cosplay materials.
- Must have scrap foamboard under material as underlayment.
- Uses replacement blade XTD-5.
- Part Number: XTD30
Demonstration Video
Logan XTD30 COS-Tools Knife Demo Video
Transcript:
To install a blade onto the Cos-Tool Knife, first loosen and remove the blade holder, install the blade onto the peg, and replace into the knife, then re-tighten the blade holding knob. To set the depth of the Cos-Tool Knife, extend the blade to the necessary depth and re-tighten the knob. To use the Cos-Tool Knife, always use foam board underlayment under the foam you intend to cut, extend the blade to the necessary depth. Now, holding the knife at a roughly 45-degree angle, draw backwards through the foam to make your cut. The Cos-Tool knife can also be used up against the Cos-Tool Channel R ...
Read More
To install a blade onto the Cos-Tool Knife, first loosen and remove the blade holder, install the blade onto the peg, and replace into the knife, then re-tighten the blade holding knob. To set the depth of the Cos-Tool Knife, extend the blade to the necessary depth and re-tighten the knob. To use the Cos-Tool Knife, always use foam board underlayment under the foam you intend to cut, extend the blade to the necessary depth. Now, holding the knife at a roughly 45-degree angle, draw backwards through the foam to make your cut. The Cos-Tool knife can also be used up against the Cos-Tool Channel Rail. Visit our website to see the entire Cos-Tool family.