Visual Magnetics Printable Magnet-15SPM - 40" x 10' White 1-Sided

Visual Magnetics Printable Magnet is a direct print magnet designed specifically for use with the Visual Magnetics Graphic System. VM-PrintableMagnet-15SPM attracts to steel and surfaces that have been primed with ActiveWall, latex primer. The standard-energy magnetic surface supports 1 MagnaMedia layer allowing for special promotions or accents to be applied on top of a base graphic.

---

Features and Benefits

• White polypropylene UV printable surface - PVC Free.
• One side printable magnet custom engineered for use with steel surfaces or ActiveWall Primer.
• Standard-energy magnet supports up to 1 MagnaMedia layer.
• Flexible rolls for application to concave and convex surfaces.
• Excellent lay flat.
• Easy to cut and trim with a utility knife or scissors.
• Magnet engineered to low gauss level for safety.

---

Application Information

• Works with steel or with ActiveWall Primer.
• Not designed for InvisiLock fixturing applications.
• Use with any MagnaMedia product.
• Pre-magnetized for use with UV flatbed print devices.
• Not designed for roll to roll devices with ferrous based printer platens.

---

Physical Data

Total Caliper	15-mil / 381 Micron
Opacity	100%
Gauss @ 0.25" gap	<1
Pull Force	120# / SF

---

Chemical Resistance

Resistant to water, detergent and alcohol. Not recommended for use in contact with aliphatic or aromatic hydrocarbons.

---

Products / Sizes

PRODUCT CODE	AVAILABLE SIZES
VM15SP-40010	40 in x 10 ft (101.6 cm x 3 m)
VM15SP-40050	40 in x 50 ft (101.6 cm x 15.2 m)
VM15SP-48050	48 in x 50 ft (121.9 cm x 15.2 m)

---

Printer Compatibility

VM-PrintableMagnet-15SPM is compatible with most UV-Cured printing technologies (see chart).

• SCREEN - Not compatible
• LITHO / OFFSET - Not compatible
• FLEXO - Uncertified – Not compatible
• THERMAL / TONER BASED - Not compatible
• HP LATEX - Not compatible
• SOLVENT (ECO) - Not compatible
• UV-CURED - VM certified best results
• DIGITAL / OFFSET - Not compatible
• WATERBASED INK JET - Not compatible

---

Recyclability

VM-PrintableMagnet-15SPM is fully recyclable / recoverable and can be reground and recovered to create new magnet material. See "Recycling Retired Graphics" program available for download at www.visualmagnetics.com.

---

Product Safety

InvisiLock magnet is a ferrite-based magnet and poses no health or safety issues. Unlike stronger, rare-earth neodymium permanent magnets, the multi-pole nature and lesser strength of ferrite magnets does not emit a strong magnetic field into the environment and therefore does not cause signal interference or damage with computerized equipment. At a gap of 0.25" or greater gauss readings are well below 1.0 and at 7 ft. the gauss level is "not recordable" using a Model 2010A Gauss Meter. Due to its low gauss emission, InvisiLock magnet is not recognized as a “magnetized material” per IATA (International Air Transportation Association) definition and therefore can be air shipped in bulk quantity.

  Technical Data Sheet
  Drytac Product Catalog 2017

Compatibility Key:   ⚫   VM certified best results     ◐   Profile dependent     X   Not compatible     △   HP Certified for Latex Inks