MHL Lustre UV 3mil 25" x 500' Low Temp Laminating Film
168.39
NewCondition
OutOfStock
We're sorry, but we no longer offer this item.
Call us at 1-800-944-4573 for personalized recommendations
or check out these similar items that may be a good fit:
MHL Lustre UV 3mil 25" x 500' Low Temp Laminating Film
SWIPE FOR MORE IMAGES
- 0
- 1
Product Description
MHL Lustre UV 3mil 25" x 500' is a low temperature, low gloss overlaminating film that is designed to reduce glare and reflection. MHL Lustre is recommended for images viewed under direct lighting conditions. Low sheen with minimal loss of contrast of sharpness makes MHL Lustre UV particularly desirable. Its many uses include POP displays, courtroom presentations, etc. Get 25" x 500' of 3mil MHL Lustre UV Low Temperature film with every order. Product number MLD25503.
Product Details
- Film Width: 25"
- Film Length: 500'
- Film Thickness: 3.0mil
- Core Size: 3"
- Finish: Luster
- Base Film: 0.5mil (13 micron) polyester
- Adhesive: 2.5 mil (62 micron) co-extruded polyethylene copolymer
- Initial Tack: None
- Application Speed: 1' - 10' per minute
- Application Temperature: 190 F - 220 F
- Release Liner: None
Item Specifications
- Specifically developed for multi-heat roller laminators (MHL) and hotshoe laminators
- Co-extruded for a carefully balanced ratio of polyester film to adhesive.
- Higher clarity for more vibrant colors, reduced "orange peel", greater rigidity (which reduces wrinkles and waves) and better adhesive flow characteristics (wet out).
- Available in a variety of thicknesses and finishes from standard gloss and lustre finishes to scratch-resistant films suitable for outdoor applications
- Suitable for both single sided and double sided laminating (encapsulation) of photographic, electrostatic, inkjet-bond, xerographic and lithographic output, as well as many more applications.
- Incorporate UV absorbers for excellent protection from damaging UV rays.
Tips
Tips For Applying MHL UV Thermal Films:
- Consider webbing your laminator with a gloss film on top and a luster film on the bottom supply shaft. This will allow you to change the surface finish by feeding in your image either face up or face down.
- Co-extruded for a carefully balanced ratio of polyester film to adhesive.
- Use your idler bar to increase the area of contact between the heated rollers and the film.
- To allow for proper heat recovery, laminators with smaller diameter rollers require a slower processing speed and / or higher operating temperature for the best results.
- MHL laminating films bond while they are cooling (thermoplastic). This means that it is important that you create a steady uniform tension with the pull rollers (and a cooling system for thicker films) to ensure a smooth, flat encapsulated print without waves or wrinkles.
