Ghent Triumph Tabletop/ Floor Display Easel

Here at [GMI], we're going to show you some of the benefits and features of our Triumph Easel. We're going to make it into a table top easel. We're going to need [some of these -- 00:05] board holders down to the bottom. There is a button that you press. It's called the snap button. We simply snap this leg off. And we're going to need to remove this. The easiest way to do that is turn it back into its sitting position and take your finger at the top and just snap it out. Do the same at the bottom and it'll pull right off. You want to come in from the back, put it back in, turn it. And again, you want to pull with your finger from the back and pull it through. And it snaps right... And if you want to place it like back on, again, pushing down the snap button as it goes through. And then you can move it all the way up. You want to do the same thing with this other leg. And finally, move your last leg back up. Place it on a table top. Move your board holders out. And place your board right on top. Again, the brace in the middle supports it, keeps it stable so it doesn't move, and hold the board up.

Here at GMI, we're going to show you some of the benefits and features of our Triumph Easel. Our Triumph Easel sits both at 62 inches high and 37. So it can be used as a table top easel and as a floor easel. When you pull it out of the box, it's going to look like this. In order to open it, you just pull out from the support bar, push down. The first one is going to be the floor easel. Get it to full height. Here at the bottom there is a button that you press. It's called the snap button. I would pull from the top. If you hold down [inaudible -- 00:32] and pull from the top, it's easier to slide down. Slide it down into position, and the button snaps at the bottom. You can do this on all three legs. After you snap all three in, you have your floor easel. Pull out your board holders, and place a board on top. As you can see, board holders keep it sturdy. And stability is created by the three legs. In order to make it into a table top easel, we're going to need some of these board holders down to the bottom. We simply snap this leg off. And we're going to need to remove this. The easiest way to do that is turn it back into its sitting position and take your finger at the top and just snap it out. Do the same at the bottom, and it'll pull right off. You want to come in from the back, put it back in, turn it. And again, you want to pull with your finger from the back and pull it through. And it snaps right. And you want to place it like back on. Again, pushing down the snap button as it goes through. And then you can move it all the way up. You want to do the same thing with this other leg. And finally, move your last leg back up. Place it on a table top. Move your board holders out and place your board right on top. Again, the brace in the middle supports it, keeps it stable so it doesn't move, and holds the board up.

Here at GMI, we're going to show you some of the benefits and features of our triumph easel. When you pull it out of the box, it's going to look like this. In order to open it, you just pull out from the support bar, push down. We get it to full height. Here at the bottom, there is a button that you press. It's called the snap button. I would pull from the top. If you hold down here, push in, and pull from the top, it's easier to slide down. Slide it down into position, and the button snaps at the bottom. You can do this on all three legs. After you snap all three in, you have your floor easel. Pull out your board holders, and place a board on top. As you can see, board holders keep it sturdy. And stability is created by the three legs.