Fujipla Pluster Single Side Deluxe Laminator PLS3310

I’m going to do the same thing again – two loads of … actually, two loads of 30. So we’re going to do 60 sheets. (Machine running) We’re ready for another load here. This time we’re going to do approximately a hundred sheets. (Machine running) Let’s increase the speed slightly to 288 inches per minute. (Machine running) Let’s do a little bit of a bond test here just to see how we’re … you know … just to make a quick X. Then we’ll peel off a portion of the film. If everything is well, we should pull [inaudible 00:08:02] which is precisely what we’re doing. We’re actually getting a better bond of the film with the image and the image is to the paper. Excellent bond. (Machine running) The speed that we’re at is 188 inches per minute. That’s at 10 plus covers per minute being produced completely automatically, virtually no operator involvement. The only operator involvement is placing the stack into the feeder section of the laminator and then hitting the ‘Start’ button. The laminator will then produce and fill the stack as we go on or until the run is interrupted by an operator, a person will stop. It’s interesting. Since we started the video, I think you’ve made a good idea [inaudible 00:09:28] how our stack is growing here. After we run this pile, we will have produced about 250 covers or so.