Logan COS-Tools V-Groove Cutter - XTC2001

$37.15
pay /mo or Net30*
Brand: Logan
Item# XTC2001
  • Cuts V-grooves in suitable Cosplay materials to perfection
  • Features include adjustable blade depth, quick change blade clips, magnetic blade slot, on-board blade storage drawer and six extra blades.
  • Use with COS-Tools XT3001 Channel Rail, Logan Adapt-A-Rule or Team System to maximize productivity
  • Use replacement blades WC-5 or WC-20.

ProductDescription

The COS-Tools XTC2001 V-Groove Cutter cuts V-grooves perfectly in suitable Cosplay materials. It is featured with an adjustable blade depth, quick change blade clips, magnetic blade slot, on-board blade storage drawer and six extra blades. To maximize its productivity, use it with COS-Tools XT3001 Channel Rail, Logan Adapt-A-Rule or Team System. The COS-Tools XTC2001 V-Groove Cutter uses replacement blades WC-5, WC-20.
IMPORTANT: Always use a scrap piece of foam board underneath the piece you are cutting. This is to protect the tool and extend the life of the blades.

Product Details

  • Features include adjustable blade depth, quick change blade clips, magnetic blade slot, on-board blade storage drawer and five blades.
  • Cuts V-grooves in suitable Cosplay materials to perfection
  • Use with FoamWerks Channel Rail, Logan Adapt-A-Rule or Team System.
  • Use replacement blades WC-5 or WC-20.
  • 90 Days Manufacturer's Warranty

Demonstration Video

Logan COS-Tools V-Groove Cutter - XTC2001 Demo Video

Transcript : To install blades onto the COS-Tool V-Groove Cutter, first remove the yellow blade clip, install one blade sharp side down onto the post, then replace the yellow blade clip. Install the other blade on the other side of the tool the same way. Find extra blade storage on the back of the tool. To adjust the blade depth of the V-Groove Cutter, find the blade depth dial on the rear of the cutter. Turning this dial either direction will increase or decrease the depth of the V-Groove. Note that the scale is both in millimeter and inch. The COS-Tool V-Groove Cutter must be used with the COS-Tool Chann ...