Page 1 of 2
Text on page 2
CardMac PowerPack
IMPORTANT
- Make sure the Power Pack is properly installed in the CardMac before plugging the power adapter into an electrical outlet.
- The Power Pack was designed only for use with the CardMac and should not be used with vany other machines.
- Avoid placing fingers or foreign objects into the openings or cutting slots. Doing so will result in injury and damage to the machine.
SAFETY INFORMATION
- Read all operating and safety instructions before using the machine.
- Observe all warnings and instructions marked on the machine.
- Install the machine on a secure and stable table.
- If the machine does not operate normally, please contact your local reseller for help.
- There are no user serviceable parts inside the machine.
- Do not remove any covers, modify or change any part of the machine. Doing so will void your warranty.
PRODUCT OVERVIEW
Power Adapter - plug this into an electrical outlet to power the Power Pack.
Power Button - hold to activate the Power Pack.
Driving Shaft - connects to the side gear of the CardMac.
Safety Lock - the Power Pack must be properly installed and locked into place to become functional.
Release Switch - press to release the Power Pack from the CardMac.
ASSEMBLY INSTRUCTIONS
Power Jack - connect the power lead from the power adapter to this jack.
Connect the Driving Shaft on the Power Pack to the side gear of the CardMac firmly. If necessary, rotate the Driving Shaft slightly for proper alignment.
Two clicking sounds should be heard while installing the Power Pack. Both the Release Button and Safety Lock will make audible clicks when installed properly.
Page 2 of 2 · End of manual
Quick start
- Connect the power lead from the power adapter to the Power Jack.
- Connect the Power Pack Driving Shaft firmly to the side gear of the CardMac, rotating the shaft slightly if needed for alignment.
- Listen for two clicks: the Release Button and Safety Lock both click when the Power Pack is installed correctly.
- Only after it is installed, plug the power adapter into an electrical outlet.
- Hold the Power Button to run the Power Pack.
- To remove it, press the Release Switch.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Power Pack does not become functional. | The Power Pack is not properly installed and locked into place. | Connect the Driving Shaft firmly to the side gear of the CardMac. Rotate the shaft slightly if needed for alignment. Listen for two clicks, from the Release Button and the Safety Lock. Page 2 |
| Risk of damage when powering up. | The power adapter was plugged in before the Power Pack was installed. | Make sure the Power Pack is properly installed in the CardMac before plugging the power adapter into an outlet. Page 2 |
| Power Pack used with another machine. | The Power Pack is designed only for the CardMac. | Do not use the Power Pack with any other machines. Page 2 |
| Injury or machine damage. | Fingers or foreign objects were placed in the openings or cutting slots. | Avoid placing fingers or foreign objects into the openings or cutting slots. Page 2 |
| Machine does not operate normally. | The cause is not covered in the manual and there are no user serviceable parts inside. | Contact your local reseller for help. Do not remove covers or modify the machine, as this voids the warranty. Page 2 |
| Machine is unstable during use. | It is not on a secure, stable table. | Install the machine on a secure and stable table. Page 2 |
Frequently asked questions
Can the Power Pack be used with other machines?
No. It was designed only for use with the CardMac (page 2).
How do I know the Power Pack is installed correctly?
You should hear two clicks, one from the Release Button and one from the Safety Lock. The Power Pack only works when it is properly installed and locked into place (page 2).
How do I take the Power Pack off the CardMac?
Press the Release Switch to release it from the CardMac (page 2).
