Page 1 of 3
Text on page 2
Megabind-1Eoperationinstructions
Introduction
with a full range of functions and premium quality components to guarantee an effortless
Important
Were commend that you take a few minutes to familiarize yourself with the functions of professional results.
Features
Binding Handle
Manual Punch Switch
Continuous Binding
DieD is engage able Pins Punching Margin Control
Side Margin Control
Binding Guide
Assembly
- PlaceyournewMEGABIND-1Eontopofasturdyworkingtable
- Removethescrewfrombindingaxle.InserttheBindingHandle,inavertical position,onto the binding axle and tighten back the screw into thepunching axle(makesurescrewiswell fastened clockwise).
- Insert the foot pedal plugin to the rear left of the machine.
- Insert the power cord plugin to the rear right of the machine.
- Make sure the punch throatisclearofanypackagingmaterial,turnonthe
Safety Instructions
- Keepfingers,hair,jewelry,necktieandanylooseclothingorobjectsaway from the punch throat.
- Do not allow children tooperate themachine.TheMEGABIND-1Eisnota
- Alwaysturnswitch-offandplacefootpedaloutofreachwhenmachineisnot
- Toreducetheriskofelectricshock,neveroperatetheMEGABIND-1Enear
Page 2 of 3
Text on page 3
- DonotusetheMEGABIND-1Eifpowercordisdamaged
- Do not allow the electric cord to be in contact with hot surfaces.
- Incaseofmalfunction,returntheunittoyourdistributorforservice.This equipment does not contain any part that can be serviced by the consumer or
Set-Up
- InsertyourfullunbounddocumentintotheBindingGuide.Thenumbertells
correct depth margin. Set Margin Control to the proper color as determined inStep 1.Youcando so by turning the Margin Control knob on the right of the machine.
Punching
- Use the Punch Throat Ruler andSide Margin Control tocenter thepunching of your document.
- Pull out Disengagement Pins for any partially covered holes.Therectangles on the Punch Ruler represent the exact position of the holes.
- Insert sheets and step on the footpedal topunch.NoTE:You may also choose to use the Manual Punching Switch to activate the punch.
Binding
- Pull the Binding Handle to open theringsof thecomb.
- Holding thepunched sheetsvertically（firstpage towardsyou),place them in
pages into the comb.
- Push the Binding Handle back to vertical position to close thecomb. Vertically takeout your finished book.
recommended to set your Continuous Binding Control to prevent over-
and turning it left or right.
Warranty
YourMEGABIND-1Ehasawarrantyofoneyear,from itspurchasedate.Intheeventof a manufacturersdefect,yourdistributor（atoption)willrepairorreplaceit.Important:this warranty does not cover damages due improper use or mishandling of theunit,including
above.If theproblem persists,pleasecontactyourdealerforfurtherinstructions.Please haveyourmachine'sserialnumberandthepurchasedateready,If the machine must
any damage incurred during its transportation will not be covered by our warranty policy
Page 3 of 3 · End of manual
Quick start
- Assemble: Put the machine on a sturdy table. Fit the Binding Handle vertically onto the binding axle and tighten the screw.
- Connect: Plug the foot pedal into the rear left and the power cord into the rear right. Make sure the punch throat is clear of packaging.
- Set the margin: Insert a full unbound document into the Binding Guide to read the depth. Set the Margin Control knob to the matching color.
- Center the punch: Use the Punch Throat Ruler and Side Margin Control to center the punching.
- Punch: Pull out Disengagement Pins for any partially covered holes. Insert sheets and step on the foot pedal. You can also use the Manual Punching Switch.
- Bind: Pull the Binding Handle to open the rings of the comb. Place the punched sheets on the comb.
- Close: Push the Binding Handle back to vertical to close the comb. Take out the finished book.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Fingers or loose items near the punch | Objects are in the punch throat area. | Keep fingers, hair, jewelry, neckties, and loose clothing away from the punch throat. Page 2 |
| Machine should not be used | The power cord is damaged or touching hot surfaces. | Do not use the machine with a damaged cord. Keep the cord away from hot surfaces. Page 3 |
| Holes are only partly covered by the paper | Holes in those positions are only partly covered by the paper. | Pull out the Disengagement Pins for any partially covered holes. Page 3 |
| Handle feels loose or the machine will not run cleanly | The handle screw is loose or the punch throat has packaging in it. | Tighten the handle screw well and make sure the punch throat is clear of packaging material. Page 2 |
| Machine malfunction | Unknown fault. | Return the unit to your distributor for service. It has no parts the user can service. Page 3 |
Frequently asked questions
How do I punch with the MEGABIND-1E?
Insert the sheets and step on the foot pedal. You can also use the Manual Punching Switch. See page 3.
How do I handle partly covered holes?
Pull out the Disengagement Pins for any partially covered holes. See page 3.
How do I open the comb?
Pull the Binding Handle to open the rings of the comb. Push it back to vertical to close the comb. See page 3.
Where does the foot pedal plug in?
Into the rear left of the machine. The power cord goes into the rear right. See page 2.
What is the warranty?
The warranty is one year from the purchase date. See page 3.
