Page 1 of 6
Page 2 of 6
Text on page 3
ETrimmed Glass Board
TYPE WALL
For Stud Walls 1/8” Predrill
Edge of Board
Wall Mount Locations on Board
16” min. 3” 24” max.
For Dry Wall 1/4” Predrill
Page 3 of 6
Text on page 4
o InstallPreparing to Install Your New Glass Board
Measure the length and width of your new board. Determine the wall center line and height off the floor that you want your new board to be located. Hold your board up in position and draw a line under the bottom of the board and parallel with the floor. If your wall has studs, determine the centerline of the studs. It is recommended that you tie into as many studs as possible when mounting your board. .
NOTE: The proper installation of your board will require at least two people. Tools required: Tape measure, chalkline, electric drill / screwdriver, drill and screwdriver bits, stud finder and level. .
2.) Measure 1” up from your line and draw a second parallel line. You will need to drill 3/16” diameter holes in the back leg of the Tray extrusion for your mounting Screws (D). See Detail #2A for location. Follow the recommended hole locations, correct wall mount anchors and correct predrill for your type wall from Page 2. Attach Tray (P2) to the wall using the correct mounting hardware for your type wall. . Drill 3/16” diameter screw holes on this line
Bottom of Board Line
Page 4 of 6
Text on page 5
3.) Place Board (P1) into the wall mounted Tray (P2) board groove.
4.) Mark a line along the top edge of the board.
Top of Board Line
5.) Draw a line 1” down from the top line. Install the L-Clips (A) using the recommended mount spacing and the correct hardware for your type wall.
Page 5 of 6
Text on page 6
Make sure your L-Clips (A) are pushed up. Place the Glass Board (P1) back into the board groove in the Tray (P2). Push the L-Clips down and secure to the top of the board using Self Drilling Screws (B) as shown in illustration #6. .
WWW.MYBINDING.COM
Page 6 of 6 · End of manual
Quick start
- Gather a tape measure, chalk line, electric drill/screwdriver, drill and screwdriver bits, stud finder and level. Plan on at least two people.
- Choose the board's center line and height, hold the board in place and draw a level line along its bottom edge. Locate studs and tie into as many as possible.
- Draw a second line 1" above the bottom line, drill 3/16" holes in the back leg of the tray, and attach the tray (P2) with hardware suited to your wall (predrill 1/8" for studs, 1/4" for drywall).
- Set the glass board (P1) into the tray groove and mark a line along its top edge.
- Draw a line 1" below the top line and install the L-clips (A) with the recommended spacing and correct wall hardware.
- With the L-clips pushed up, set the board back in the tray groove, push the clips down and secure them to the top of the board with the self-drilling screws (B).
Frequently asked questions
How many people are needed to install the Balt 14800 glass board?
The instructions say proper installation requires at least two people. See page 4.
What size pilot holes do I drill?
Predrill 1/8" for stud walls and 1/4" for drywall. The tray itself needs 3/16" holes for the mounting screws. See page 3 and page 4.
What tools are required?
A tape measure, chalk line, electric drill/screwdriver, drill and screwdriver bits, stud finder and level. See page 4.
