Page 1 of 6
Page 2 of 6
Text on page 3
WOW
Visionary Move
Screw 1/4 X 15mm
NOTE: You will not use the Assembly Instructions or Hardware that are included in the Glass Board packages.
Page 3 of 6
Text on page 4
Visionary Move
Assembly Diagram
R EAD T HROUGH I NSTRUCTIONS FROM BEGINNING
TO END BEFORE STARTING TO ASSEMBLE UNIT .
To Assemble: 1.) Identify and Seperate all the Parts and Hardware.
2.) Place a Lock Washer (E) on each Caster’s stem and screw in one Locking Caster(C1) and one Non-Locking Caster (C2) into the bottom of each Leg (P2). Tighten Casters with Caster Wrench (D) as shown in illustration #1.
Attach the Bottom Post (P5) in between the Legs (P2) using two Screws (B) for each as shown. Make sure the feet on the Legs(P2) are point in to each other. Tighten Screws using Allen Wrench (E). See illustration #2.
Page 4 of 6
Text on page 5
4.) Insert the Vertical Tubes (P4) into the Horizontal Tubes (P3) as shown in illustration #3. Make sure the holes in the Vertical Tubes are oriented as shown. Top
Slide the assembly from Step 4 in between the Leg assembly from Step #3. Align the holes and connect using two Screws (B) through each side as shown in illustration #4.
Frame Assembly
Leg Assembly
Page 5 of 6
Text on page 6
Attach the Tray (P6) to the bottom of the frame assembly using three Screws (A). Tighten Screws with Allen Wrench (E) as shown in illustration #5.
7.) Place a Glass Board (P1) into the Tray’s (P6) inner flanges in front of the frame on both sides. Hold the two Glass Boards against the frame and lower the Top Cap (P7) over the top as shown in illustration #6. Secure the Top Cap (P7) to the top frame member using three Screws (A). Tighten all Screws using Allen Wrench (E).
WWW.MYBINDING.COM
Page 6 of 6 · End of manual
Quick start
- Identify and separate all parts and hardware. Do not use the instructions or hardware packed with the glass boards.
- Put a Lock Washer (E) on each caster stem and screw one Locking Caster (C1) and one Non-Locking Caster (C2) into the bottom of each Leg (P2).
- Attach the Bottom Post (P5) between the legs with two Screws (B) each, with the leg feet pointing toward each other.
- Insert the Vertical Tubes (P4) into the Horizontal Tubes (P3) with the holes oriented as shown, then slide the frame between the legs and connect with two Screws (B) per side.
- Attach the Tray (P6) to the bottom of the frame with three Screws (A).
- Set a Glass Board (P1) into the tray's inner flanges on each side, hold both against the frame, lower the Top Cap (P7) over the top and secure with three Screws (A).
Frequently asked questions
Do I use the hardware that comes with the glass boards?
No. The assembly instructions and hardware included in the glass board packages are not used with the Visionary Move. See page 3.
Does the Visionary Move hold boards on both sides?
Yes. One glass board sits in the tray flanges on each side of the frame, held at the top by the Top Cap (P7). See page 6.
Do the casters lock?
Each leg gets one Locking Caster (C1) and one Non-Locking Caster (C2). See page 4.
