Banner Bug Retractable Banner Stand - Silver BannerBug Assembly Instructions, page 1
Text on page 1

Assembly Instructions

  1. Remove the base and folded support rod, which features shock cord tubes similar to those found in camping tent poles.
  2. Straighten out the rod so it becomes one long pole, inserting the smaller, darker portions of each section into the hole of another section. The top portion of the support rod is the same diameter as the rest of the pole. The bottom portion of the support rod narrows at the end and has a bright aluminum ring. Insert the bottom portion into the hole in the base of the BannerBug ® .
  3. Gently raise the banner from the retractable base until it is the same height as the support rod.
  4. Attach the banner to the rod by inserting the black, plastic hook attached to the top rail into the top of the pole.

NOTE: If you want to shorten your banner stand, do not connect the top portion of the shock cord rod and leave it hanging. Instead, attach the banner to the second highest rod by inserting the black, plastic hook attached to the top rail into the top of that part of the pole.

USA Drytac Corporation customerservice@drytac.com 1.800.280.6013

CANADA

Drytac Canada toronto@drytac.com 1.800.353.2883

Rev May 2014

For tall systems, it is easier to attach and detach the banner from the rod by tilting the banner stand or laying it on a table.

Page 1 of 1 · End of manual

Quick start

  1. Remove the base and the folded shock-cord support rod.
  2. Straighten the rod into one long pole, pushing the smaller, darker end of each section into the next.
  3. Insert the bottom section (the one that narrows and has a bright aluminum ring) into the hole in the BannerBug base.
  4. Gently raise the banner from the base until it is level with the top of the rod.
  5. Insert the black plastic hook on the banner's top rail into the top of the pole.

Frequently asked questions

Can I make the BannerBug shorter?

Yes. Leave the top rod section unconnected and hanging, and hook the banner's top rail into the second-highest section instead. See page 1.

Which end of the rod goes into the base?

The bottom section, which narrows at the end and has a bright aluminum ring. See page 1.

Is there an easier way to attach the banner on tall stands?

Tilt the stand or lay it on a table when attaching or detaching the banner from the rod. See page 1.