Banner Bug Retractable Banner Stand - Silver Graphic Replacement Instructions, page 1
Text on page 1
  1. Release the graphic panel completely from the system to expose the PVC tongue and graphic join. Place the pin into the side of the unit when the hole on the roller lines up with the hole in the end cap.
  2. Carefully remove the existing graphic panel from the PVC tongue. Add 0.78” (20mm) hook tape (male) to the base of the new graphic panel and then place in the same position.
  3. Slide the top rail off the old graphic panel and carefully remove the grey PVC strip (female loop attached) from the print.
  4. Add 0.63” (16mm) hook tape (male) to the top of the new graphic panel and apply the existing grey PVC strip.
  5. Fold the top of the new graphic backwards once and then slide into the top rail.
  6. While carefully holding the graphic, remove the pin from the side of the system and gently allow the graphic to roll back into the unit.

USA Drytac Corporation customerservice@drytac.com 1.800.280.6013

CANADA

Drytac Canada toronto@drytac.com 1.800.353.2883

Rev May 2014

Graphic Replacement Instructions

Page 1 of 1 · End of manual

Quick start

  1. Pull the graphic fully out to expose the PVC tongue and join. When the roller hole lines up with the end cap hole, insert the pin into the side of the unit.
  2. Remove the old graphic from the PVC tongue. Apply 0.78" (20mm) male hook tape to the base of the new graphic and place it in the same position.
  3. Slide the top rail off the old graphic and remove the grey PVC strip from the print.
  4. Apply 0.63" (16mm) male hook tape to the top of the new graphic and attach the grey PVC strip.
  5. Fold the top of the new graphic backwards once and slide it into the top rail.
  6. Hold the graphic, remove the pin and let the graphic roll back gently into the unit.

Frequently asked questions

What size hook tape do I need for a new BannerBug graphic?

0.78" (20mm) male hook tape for the base of the graphic and 0.63" (16mm) male hook tape for the top. See page 1.

How do I stop the graphic retracting while I change it?

Pull the graphic all the way out and insert the pin into the side of the unit when the roller hole lines up with the end cap hole. See page 1.

Who do I contact for support?

Drytac: customerservice@drytac.com or 1.800.280.6013 in the USA, and toronto@drytac.com or 1.800.353.2883 in Canada. See page 1.