Page 1 of 3
Text on page 2
through instructions from beginning to end before 1 Read starting this Installation.
R EAD T HROUGH I NSTRUCTIONS FROM BEGINNING
TO END BEFORE STARTING THIS INSTALLATION .
measure the surface area to be covered with a
3 Accurately
tape measure.
2 Clean boards surface thoroughly.
N OTE :T HIS INSTALLATION REQUIRES TWO
P EOPLE .
Use the Sponge (P-2) dipped in a Mixture of Water and Alcohol to clean the surface being covered and to aid in positioning and moving the New-Rite Surface. This mixture will dry without effecting the bond.
your New-Rite Surface (P-1) to exactly fit the 4 Cut surface area using a utility knife.
5 Test fit the New-Rite Surface.
Start on the left hand side of the board. Start peeling the protective backer to expose the adhesive back.
Page 2 of 3
Text on page 3
7 Clean Surface
6 Apply New-Rite Material.
Align the New-Rite with the left side edge making sure you are straight with the top and bottom edges.
Use the Sponge (P-2) with soap and water to clean and remove all residue on the surface.
Slowly remove the protective bacer as you start pressing the New-Rite surface to the board. Take care not to trap air bubbles under the surface. Slowly work to the right side of the board.
Use the Squeegee (P-3) to press the New-Rite down and force air bubbles out.
A Roller can be used to help work out any wrinkles or air bubbles.
Should you require assistance during assembly, please call our Customer Service Department Monday - Friday 8 a.m. - 5 p.m. Central Standard Time
Toll-Free Customer Service
WWW.MYBINDING.COM
Page 3 of 3 · End of manual
Quick start
- Read the instructions from beginning to end before starting. This installation requires two people.
- Clean the board surface thoroughly using the Sponge (P-2) dipped in a mixture of water and alcohol.
- Accurately measure the surface area to be covered with a tape measure.
- Cut the New-Rite Surface (P-1) to exactly fit the surface area using a utility knife, then test fit it.
- Starting on the left side, peel back the protective backer, align the New-Rite with the left edge and keep it straight with the top and bottom edges.
- Slowly remove the backer as you press the surface onto the board, working toward the right side. Use the Squeegee (P-3) to press it down and force out air bubbles.
- Clean off all residue with the Sponge (P-2) and soap and water.
Frequently asked questions
How many people does the installation need?
Two people (page 2).
What do I clean the board with before applying the surface?
Use the Sponge (P-2) dipped in a mixture of water and alcohol. The mixture also helps you position and move the New-Rite surface, and it dries without affecting the bond (page 2).
How do I get rid of air bubbles or wrinkles?
Press the surface down with the Squeegee (P-3) to force air bubbles out. A roller can also help work out wrinkles or air bubbles (page 3).
What do I use to cut the New-Rite surface?
A utility knife. Cut it to exactly fit the measured surface area, then test fit it before peeling the backer (page 2).
