Best-Rite 4' x 4' Dry-Erase Markerboard with USA Map Assembly Instruction, page 1
Text on page 1

Note: Install Masonry Anchors (D) into 1/4” Diameter predrill holes for masonry walls.

d oar

at Loc

ion

Install Drywall Anchors (E) into 1/4” Diameter predrill holes for sheet rock walls.

Top Edge of Board

Bo

Bottom Edge of Board

1 Determine board location. Measure from floor to

the bottom edge of board. Mark with pencil line the corner location. Measure up from bottom edge of board 1-1/4” and draw line as shown. Locate stud near each end of board and drill pilot holes along line using 1/8” drill bit. See diagram below.

Edge of Board

Bo

ard

a Loc

16” min. 6” 24” max.

Angle Bracket

Edge of Board

tion

tion

Equally Spaced

Angle Bracket Locations on Board

ard

a Loc

3 Set board on the Angle

Lift and remove board from the angle brackets. Measure down from top line of board 1” and draw line as shown. Locate stud near each end of board and drill pilot hole along line using 1/8” drill bit.

Brackets. Draw line along top edge of board.

½ the # of Angle Brackets using

2 Attach

Long Screws (B) as shown.

board to bottom and

5 Secure top Angle Brackets (A) to the wall using 6 Secure

top brackets (A) using short

long screws (B) as shown. Follow diagram in

  1. Set board on the bottom angle brackets.

screws (C) as shown.

Page 1 of 1 · End of manual

Quick start

  1. Measure from the floor to where the bottom edge of the board will sit and mark the corner location with a pencil line.
  2. Measure up 1-1/4" from the bottom-edge line and draw a line. Locate a stud near each end of the board and drill pilot holes along the line with a 1/8" bit.
  3. Attach half of the angle brackets along this line with the long screws (B), spaced equally.
  4. Set the board on the angle brackets and draw a line along its top edge.
  5. Lift the board off. Measure down 1" from the top line, draw a line, and drill pilot holes at the studs with a 1/8" bit.
  6. Secure the top angle brackets (A) to the wall with long screws (B).
  7. Set the board on the bottom angle brackets and secure it to the bottom and top brackets with short screws (C).
  8. On masonry walls, set masonry anchors in 1/4" predrilled holes. On drywall, use drywall anchors in 1/4" predrilled holes.

Frequently asked questions

How is the 4' x 4' USA map markerboard mounted?

It hangs on angle brackets (L-Clips): a bottom row of brackets holds the board, and a top row is added and screwed to the board with short screws (page 1).

What anchors do I use on drywall or a masonry wall?

Use masonry anchors in 1/4" diameter predrilled holes for masonry walls and drywall anchors in 1/4" diameter predrilled holes for sheetrock walls (page 1).

How far apart should the angle brackets be?

The diagram shows the angle brackets equally spaced, 16" minimum and 24" maximum apart (page 1).

What size drill bit do I need?

Pilot holes into the studs are drilled with a 1/8" drill bit near each end of the board (page 1).