Best-Rite 820 Assembly Instructions, page 1
Text on page 1

on a Knob (P2) on the threaded

1 Screw

stud on each side of Easel Frame (P1)

the Thumb Screws on the bottom of Easel Frame the legs and Loosen the Knobs (P2).

4 Spread 3 Loosen

(P1). Attach Tray (P4) and tighten Thumb Screws Raise the board and tighten the Knobs

Push in a Cap (P3) in each Knob (P2)

T humb Screws

the protective film next to the trim with a box the Clip Board top to insert and hold paper 5 Cut 6 Lift cutter and peel it off each board’s surface. or tablet.

Protective Film

Box Cutter

Page 1 of 1 · End of manual

Quick start

  1. Screw a Knob (P2) onto the threaded stud on each side of the Easel Frame (P1) and push a Cap (P3) into each knob.
  2. Loosen the thumb screws on the bottom of the frame, attach the Tray (P4) and tighten the thumb screws.
  3. Spread the legs, loosen the knobs, raise the board and tighten the knobs.
  4. Cut the protective film next to the trim with a box cutter and peel it off each board surface.
  5. Lift the clip board top to insert and hold paper or a tablet.

Frequently asked questions

How do I remove the protective film?

Cut the film next to the trim with a box cutter and peel it off each board surface (page 1).

How is the tray attached?

Loosen the thumb screws on the bottom of the easel frame, fit the Tray (P4) and tighten the thumb screws (page 1).

Can it hold a paper pad?

Yes. Lift the clip board top to insert and hold paper or a tablet (page 1).