Best-Rite 841C Assembly Instructions, page 1
Text on page 1

2 Locate centers of 4 holes and Drill as shown.

1 Locate bottom of cabinet

3 Install 4 Wall Anchors (B). Insert 4 Screws (A)as shown.

4 Align Brackets with Screws and hang Cabinet.

Dis tan ce to

Bo ttom of C abi net

Bo

Detail View bracket-Screw

Align brackets on back of cabinet with screws. slide Cabinet to the right about 1-1/4” until it slides down.

Locate and Drill pilot 5 holes along line using 1/4” drill bit.

5 Attach Security Bracket to bottom of Cabinet.

S ass hould em y bly ou r , p equ lea se re as Mo c nd all sista ay

  • F Depa our C nce d rid ay rtme ustom uring Tol S 8 a. nt er Se l-F tand m. rvi ree ard 5 p ce 1-8 Custo Time .m. Ce 00- me ntr al 74 r S

9-2 ervi 258 ce

Align brackets on back of cabinet with screws. slide Cabinet to the right about 1-1/4” until it slides down.

atio

5 Align Brackets with Screws and hang Cabinet.

Be sure the Head of the Screw is 1/4” away from wall.

Loc

Determine location for bottom of Cabinet. Mark location with a pencil line. Measure up from bottom edge of Cabinet 1-1/4 and draw line as shown. Measure up from bottom edge of Cabinet 1-3/4” and draw line as shown.

ard

3’X3’ Wall Mount Markerboard Cabinet - Oak

Page 1 of 1 · End of manual

Quick start

  1. Decide where the bottom of the cabinet goes and mark it with a pencil line.
  2. Measure up 1-1/4" and 1-3/4" from that line and draw lines as shown.
  3. Locate the centers of the 4 holes and drill pilot holes with a 1/4" drill bit.
  4. Install 4 Wall Anchors (B) and insert 4 Screws (A), leaving each screw head 1/4" away from the wall.
  5. Align the brackets on the back of the cabinet with the screws and slide the cabinet about 1-1/4" to the right until it drops down.
  6. Attach the security bracket to the bottom of the cabinet.

Frequently asked questions

How far should the screws stick out from the wall?

Leave the screw head 1/4" away from the wall so the cabinet brackets can hook on (page 1).

What size drill bit is needed?

A 1/4" drill bit for the pilot holes (page 1).

How does the cabinet lock onto the screws?

Line up the brackets on the back with the screws, then slide the cabinet about 1-1/4" to the right until it drops down. A security bracket is then attached at the bottom (page 1).