Page 1 of 2
Text on page 2
Z-Hangers
2 Attach
for mounting.
and Drill holes
1 Locate
for Z-Hangers.
3 Hang board and mark bottom
4 Remove board and drill
Top Edge of Board
Hang board on the Z-Hangers using the Hanging brackets mounted on the back of the board. Draw line along bottom edge of board.
Bo
ard
tio oca
Determine board location. Measure from floor to the top edge of board. Mark with pencil line the corner location. Measure down from top edge of board 1-5/8”, and draw line as shown. Locate stud near each end of board and drill pilot hole along line using 1/16” drill bit.
Lower Brackets and
5 Attach
Hang board
Bo
oc rd L
atio
oca
tion
Bottom Edge of Board
Lift and remove board from the Z-Hangers. Measure up from bottom line of board 1-1/8”, and draw line as shown. Locate stud near each end of board and drill pilot hole along line using 1/16” drill bit.
6 Secure Board
S ass hould em y bly ou r , p equ lea se re as Mo cal sis nd ta l o ay
- F Depa ur C nce d rid ay rtme ustom uring Tol S 8 a. nt er Se l-F tand m. rvi ree ard 5 p ce .
1-8 Custo Time m. Ce
00- me ntr al 7 r
Secure 2 bottom brackets to the wall using 2 long screws as shown. Hang board on the Z-Hangers using the Hanging brackets mounted on the back of the board.
Hanging Brackets on back of board
Attach 2 Z-Hangers using 2 Long Screws as shown
Bo
L ard
Secure board to bottom brackets using 2 short screws as shown.
49- Serv 225 ice
SPLASH CORK
E300Px-T1 Tackboard
Page 2 of 2 · End of manual
Quick start
- Measure from the floor to the top edge of the board and mark the corner location.
- Draw a line 1-5/8" below the top edge and drill a pilot hole into a stud near each end with a 1/16" bit.
- Attach the 2 Z-hangers with 2 long screws.
- Hang the board on the Z-hangers using the hanging brackets on its back and draw a line along the bottom edge.
- Remove the board, draw a line 1-1/8" above the bottom line and drill pilot holes into the studs.
- Secure the 2 bottom brackets with 2 long screws, rehang the board and fasten it to the bottom brackets with 2 short screws.
Frequently asked questions
How does the board hang on the wall?
Hanging brackets on the back of the board hook over 2 Z-hangers screwed to the wall, and 2 bottom brackets hold the lower edge (page 2).
What size pilot holes are needed?
The instructions call for a 1/16" drill bit for the pilot holes in the studs (page 2).
Where do the bottom brackets go?
After hanging the board and marking its bottom edge, remove it and draw a line 1-1/8" above that mark. The 2 bottom brackets go along this line (page 2).
