Best-Rite Green-Rite Eco Friendly Markerboard Assembly Instruction, page 1
Text on page 1

2 Attach Z-Hangers for mounting.

1 Locate and Drill holes for Z-Hangers.

Top Edge of Board

3 Hang board and mark bottom

4 Remove board and drill

d L oar

oca

tion

Lift, Tilt, and Slide Board down over the Z-Hangers. Z-Hangers should catch in the top trim on the back of the board. Draw line along bottom edge of board.

Bo

ard

at Loc

ion

ar Bo

at Loc

ion

Determine board location. Measure from floor to the top edge of board. Mark with pencil line the corner location. Measure down from top edge of board 3/4”, and draw line as shown. Locate stud near each end of board and drill pilot hole along line using 1/16” drill bit.

Attach 2 Z-Hangers (E) using 2 Long Screws (A) as shown.

Bottom Edge of Board

Z Brackets hang in the trim on back of board

Lift and remove board from the Z-Hangers. Measure up from bottom line of board 1-1/8”, and draw line as shown. Locate stud near each end of board and drill pilot hole along line using 1/16” drill bit.

6 Secure Board & Attach Q-Tray

5 Attach Lower Brackets and Hang board

Peel off protective film and wipe Sh o board with Soft cloth ass uld em yo bly u r , p equ lea se re as Mo cal sis nd ta l ay D P-2 ep our C nce

  • F d rid art me ustom urin ay n Tol S 8 a. t er g Se l-F tand m. rvi ree ard 5 p ce . C m T

1-8 usto ime . Ce

00- me ntr al 74 r S

9-2 ervi 258 ce

Secure 2 bottom brackets (F) to the wall using 2 long screws (A) as shown. Hang board on the Z-Hangers (E).

Secure board to bottom brackets

  1. using 2 short screws (B) as shown.

2X3,3X4,4x4,4x6,4x8 Porcelain Presidential Trim

Screw Anchor - Concrete 8 EA

Screw Anchor - Drywall

E2H2PB_04/21/10

E2H2PB,PC,PD,PG,PH

Page 1 of 1 · End of manual

Quick start

  1. Decide where the board goes and mark the top edge. Draw a line 3/4" below the top edge, find a stud near each end and drill a pilot hole on the line with a 1/16" bit.
  2. Attach two Z-hangers (E) with two long screws (A).
  3. Lift, tilt and slide the board down over the Z-hangers so they catch in the top trim, then draw a line along the bottom edge.
  4. Remove the board. Measure 1-1/8" up from the bottom line, find the studs and drill pilot holes with a 1/16" bit.
  5. Secure two bottom brackets (F) with two long screws (A), then hang the board on the Z-hangers.
  6. Fasten the board to the bottom brackets with two short screws (B), attach the tray, peel off the protective film and wipe the board with a soft cloth.

Frequently asked questions

What drill bit do I need to hang the Green-Rite markerboard?

The sheet calls for pilot holes drilled with a 1/16" bit at stud locations (page 1).

Does it come with wall anchors?

The hardware list includes screw anchors for concrete and for drywall.

What should I do before first use?

Peel off the protective film and wipe the board with a soft cloth.