Best-Rite Rubber Tak Bulletin Board with Aluminum Trim Assembly Instruction, page 1
Text on page 1

2 Attach bottom Angle Brackets.

and Drill holes

1 Locate

for bottom Angle Brackets.

3 Hang board and mark top.

4 Remove board and drill

Top Edge of Board

Bo

rd L

tio oca

Bo

ard

at Loc

ion

Bo

ard

a Loc

tion

Bottom Edge of Board

Determine board location. Measure from floor to the bottom edge of board. Mark with pencil line the corner location. Measure up from bottom edge of board 1-1/4”, and draw line as shown. Locate stud near each end of board and drill pilot holes along line using 1/16” drill bit.

Lift and remove board from the angle brackets. Measure down from top line of board 1”, and draw line as shown. Locate stud near each end of board and drill pilot hole along line using 1/16” drill bit.

Equally Spaced

Attach ½ the # of Angle Brackets using Long Screws

  1. as shown.

Set board on the Angle Brackets. Draw line along top edge of board.

top Angle Brackets and

5 Attach

Hang board

6 Secure Board

S ass hould em y bly ou r , p equ lea se re as Mo c nd all sista ay nc D e our

  • F rid part Cus e dur m a t Tol S y 8 a. ent omer S ing l-F tand m. erv ree ard 5 p ice . C m T

1-8 usto ime . Ce

00- me ntr al 74 r S

9-2 ervi 258 ce

Secure top Angle Brackets (A) to the wall using long screws (B) as shown. Set board on the bottom angle brackets.

Secure board to bottom and top brackets (A) using short screws (C) as shown.

321A Series

Screw Anchor - Concrete 8 EA

Screw Anchor - Drywall

d d nte boar u o k ll M /Tac a

W ard on

bo llati r e rk Insta a M

Page 1 of 1 · End of manual

Quick start

  1. Mark the bottom edge of the board, draw a line 1-1/4" above it and drill pilot holes at studs with a 1/16" bit.
  2. Attach half of the angle brackets with long screws, equally spaced.
  3. Set the board on the brackets and draw a line along its top edge.
  4. Remove the board, measure 1" down from the top line and drill pilot holes at the studs.
  5. Fasten the top angle brackets (A) with long screws (B) and set the board on the bottom brackets.
  6. Secure the board to the top and bottom brackets with short screws (C).

Frequently asked questions

What drill bit is used for the Rubber-Tak board pilot holes?

A 1/16" drill bit, at stud locations (page 1).

Are wall anchors included?

The hardware list includes screw anchors for concrete and for drywall.