Page 1 of 10
Page 2 of 10
Text on page 3
TABLE OF CONTENTS
CONTENTS
PAGE
READ CAREFULLY BEFORE USING
Proper care of your new shredder will ensure many years of trouble free operation, with minimum of maintenance or repair.
IMPORTANT:
Please note that all packaging should be retained by the customer for (30) days from the time of receipt. In the event that this unit needs to be sent back for replacement or repair this packaging will be required to do so. Should the packaging have been discarded before the (30) day requested period, packaging costs may be incurred by the customer.
SPECIFICATIONS
MEDIA SHREDDER
Security Level:
Shred Size: 4 mm x 15 mm
Feed Width: 6 1 ⁄ 2 ”
Bin Capacity: 4 gal.
Dimensions: 21.75” X 21.75” X 39.5”
Power Supply:
115v 50/60 Hz 15 Amp
Warranty includes labor but excludes wearable parts.
Page 3 of 10
Text on page 4
IMPORTANT SAFETY PRECAUTIONS
Your new shredder features powerful cutting mechanisms that may cause serious injury. Please follow all safety precautions.
- Only store, transport, and operate the shredder in an upright position!
- All liquids and gases used on the shredder must comply with Dahle guidelines!
- The shredder must only be operated in enclosed spaces at temperatures of 15 °C to
32 °C(59 °F–90 °F) and non-condensed humidity of 15% to 95%!
- Do not place the shredder near a heat source!
- Ensure the shredder is firmly on the floor at a distance of 4” from the wall; activate
- Avoid any accumulation of heat!
- The mains socket must be grounded and easily accessible at all times!
- Use only the power cord supplied with the device by Dahle and ensure that it is not
- Ensure that the building installation has short-circuit protection: max. 16 A (US
- Do not use near flammable liquids and gases!
- Do not use near caustic substances!
- Do not subject to moisture!
- Do not open up the machine!
- Automatic start-up!
- Switch off the shredder at the main switch when not in use!
- Only use the shredder provided that it is in perfect working order, while observing
the operating instructions and the usual regulations, guidelines and applicable safety and accident prevention requirements. Take the shredder out of service immediately if faults occur!
- The device is not intended for use by persons (including children) with restricted
physical, sensory or mental capabilities or a lack of experience and knowledge, unless they are working under supervision or receive detailed instruction about how to use the device from a person who is responsible for safety.
Page 4 of 10
Text on page 5
IMPORTANT SAFETY PRECAUTIONS
It is obligatory to follow the safety instructions!
Read the operating instructions carefully before using the shredder!
This shredder is not intended to be used by children (the product is not a toy)!
Do not touch the feed opening with your hands!
Do not allow items of clothing to touch the feed opening!
Do not allow your hair to touch the feed opening!
Prior to maintenance work, disconnect the shredder from the power supply!
INSTALLATION
- Insert supplied waste bin into the shredder.
- Plug shredder directly into a wall outlet.
Do not use a power strip or extension cord.
Page 5 of 10
Text on page 6
OPERATION
POWER ON
- Turn on both power switches. One is located inside the door and the other is on the right side of the shredder.
AUTO START
- Press the START button. The AUTO LED will illuminate and the shredder will run for 1 minute.
- AUTO mode switches off after five (5) minutes of no activity.
MANUAL MODE
- With the AUTO button illuminated, push the START button again. The MANUAL LED will illuminate, and the shredder will begin to run. Insert media through bypass chute. Press the START button again to turn off Manual mode.
REVERSE MODE
- Pushing the REV button will illuminate the REV LED and the shredder will operate in reverse. Use this function if too much media is inserted and a jam occurs.
BAG FULL
- When the waste container is full, the FULL LED will illuminate, and the shredder will stop automatically. Open the door, remove and empty the waste container. Replace the waste container, close the door, and press the START button to resume shredding.
OPEN
- When the door is open the OPEN LED will illuminate and the shredder will not operate. Close the door to resume shredding.
Page 6 of 10
Text on page 7
MAINTENANCE
- After emptying the waste container, we recommend to press
and hold the REV button for 5 seconds to initiate a cleaning cycle. This cleaning will take 1 minute and the machine will return to AUTO mode when complete.
- Switch off the shredder and disconnect power by removing
power cord from wall outlet.
- Clean the exterior of the machine with a soft cloth. Do not
use harsh detergents or chemicals.
WARRANTY
Dahle guarantees it’s industrial shredders to be free from manufacturing defects (materials / workmanship) for a period of one year.
This warranty shall not apply to wearable items or defects caused by ordinary wear and tear, insufficient maintenance or improper operation. This warranty applies to the original purchaser only and is not transferable. There are no other warranties expressed or implied beyond the face of this agreement.
Page 7 of 10
Page 8 of 10
Page 9 of 10
Text on page 10
Dahle North America, Inc. 49 Vose Farm Road Peterborough, NH 03458 Tel. (800) 995-1379 info@dahle.com
www.dahle.com
Page 10 of 10 ยท End of manual
Quick start
- Insert the supplied waste bin into the shredder.
- Plug the shredder directly into a wall outlet. Do not use a power strip or extension cord.
- Turn on both power switches: one inside the door and one on the right side.
- Press START. The AUTO LED lights and the shredder runs for 1 minute.
- For MANUAL mode, press START again with AUTO lit and insert media through the bypass chute. Press START again to turn Manual mode off.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Media jam | Too much media was inserted. | Press REV to run the shredder in reverse. Page 6 |
| Shredder stops and the FULL LED is lit | The waste container is full. | Open the door, empty the waste container, put it back, close the door and press START. Page 6 |
| Shredder will not run and the OPEN LED is lit | The door is open. | Close the door to resume shredding. Page 6 |
Frequently asked questions
What shred size does the PowerTEC 808 MS produce?
4 mm x 15 mm, with a 6 1/2" feed width and a 4-gallon bin (page 3).
How do I clear a jam?
Press REV to run the shredder in reverse (page 6).
How do I run a cleaning cycle?
After emptying the waste container, press and hold REV for 5 seconds. The cycle takes 1 minute (page 7).
What is the warranty?
One year against manufacturing defects for the original purchaser; wearable items are excluded (page 7).
