Page 1 of 14
Text on page 2
The following conditions apply to the performance in terms of sheets listed under technical data:
IMPORTANT!
Read the operating and safety instructions BEFORE placing the document shredder into operation. You must follow the instructions. Keep the operating instructions in a safe place ready for later use.
Maximum number of sheets that are shredded in one pass under the following conditions: New cutting rollers, oiled if needed, cold motor, power supply with nominal voltage and nominal frequency (230 V/50 Hz; 120 V/60 Hz). Deviations may result in reduced sheet processing and increased operating noises. The sheets are fed centrally and lengthwise at a 90 degree angle. The performance in terms of sheets can also vary depending on the paper properties and input.
Important information . . . . . . . . . . . . . . . 6 Scope of supply . . . . . . . . . . . . . . . . . . 60 Technical specifications . . . . . . . . . . . . . 60 Operation . . . . . . . . . . . . . . . . . . . . . . 61 Paper shredding . . . . . . . . . . . . . . . . . 62 Card shredding . . . . . . . . . . . . . . . . . . . . 64 Maintenance / troubleshooting . . . . . . . . 65 Emptying shredding waste . . . . . . . . . . . . 65 Overheated . . . . . . . . . . . . . . . . . . . . . . 66 Overload . . . . . . . . . . . . . . . . . . . . . . . . 66 Cleaning the shredder . . . . . . . . . . . . . . . 69
- Do not place the device near a source of heat.
- Store, transport and operate the device in an upright position only.
- Only use liquids and gases on the device that comply with DAHLE guidelines.
- Do not open up the device.
- Only operate the device in closed spaces, at temperatures of between 10 °C and 25 °C (50 °F to 77 °F) and at a non-condensing humidity of between 15% and 95%.
- Ensure that the building installation has shortcircuit protection: max. 16 A (US max. 20 A).
- Do not operate the document shredder without inserting documents.
- The device is not intended for use by persons (including children) with restricted physical, sensory or mental capabilities or a lack of experience and knowledge, unless they are working under supervision or receive detailed instruction about how to use the device from a person who is responsible for safety.
The document shredder is intended to be used for shredding paper. Depending on the model variant, a small amount of the following materials can also be shredded:
- CDs/DVDs, bank cards and credit cards (see technical data).
- The normal staples and paper clips found in paper documents (exception: security level P6 and P7 devices).
Wear, damage due to improper use or unauthorised modifications and repairs are not covered by the warranty or the guarantee.
Dispose of the document shredder properly in an environmentally friendly way at an authorised collection point. Do not dispose of any parts of the document shredder or packaging in domestic waste.
The document shredder was designed for private use and for use in normal office environments.
Page 2 of 14
Text on page 3
Noise level when operated without shredding documents
WARNING
Do not use near caustic substances.
Place the device in a stable position on the floor, leaving a gap of 100 mm to the wall, ensure no heat can accumulate, engage brake mechanisms (depending on type) Do not use near inflammable liquids or gases.
The power plug is used to disconnect the power supply.
The mains socket must be easily accessible at all times.
Do not expose to moisture
Document shredder on standby
This document shredder is not intended to be used by children (the product is not a toy).
Document shredder in operation
Do not touch the paper feed with your hands.
Do not allow items of clothing to come into contact with the paper feed.
The document shredder will switch off automatically to cool down if used for a long time and /or if overloaded
Do not allow your hair to come into contact with the paper feed.
Maintenance instructions / troubleshooting
Keep spray cans away from the device.
Remove paper clips and staples before shredding.
Do not insert any diskettes/CDs/DVDs.
Automatic switch-off when housing is open
Disconnect the document shredder from the electrical power supply before performing maintenance work. Technical specifications - Subject to technical modifications.
MyBinding.com 5500 NE Moore Court Hillsboro, OR 97124 Toll Free: 1-800-944-4573 Local: 503-640-5920
Page 3 of 14
Text on page 4
Wir erklären n in alle alleiniger Verantwortlichkeit, dass der DAHLE Aktenvernichter* den einschlägigen G Sicherheits- - d Gesundheitsanforderungen der EG-Produktsicherheitsrichtlinie** entspricht. Das Gerät stimmt üb en folgenden harmonisierten Normen*** und Spezifikationen****, gemäß d ngen der Richtlinien*****. Ausgabe******.
5m/min
70 g/m max. 8
1,8m/min
max. 80
US letter
20 lb max. 80
80 g/m max. 8
220 - 240 V / 50 - 60 Hz 110 - 120 V / 50 - 60 Hz
US letter
20 lb max. 8
DIN 66399 P-4 / F-1
4,3 x 10 mm
DIN 66399 T-4 / E-2
x. ma m m 222 5“ 8.7
502 mm 19.76“
8.5 8 mm 8“
≤68 dB (A)
mm “ 331 13.03
17 l / 4.5 gal
8,4 kg 18.5 lbs
Page 4 of 14
Page 5 of 14
Page 6 of 14
Page 7 of 14
Page 8 of 14
Page 9 of 14
Page 10 of 14
Page 11 of 14
Page 12 of 14
Page 13 of 14
Page 14 of 14 ยท End of manual
Frequently asked questions
Under what conditions is the rated sheet capacity measured?
New cutting rollers, oiled if needed, a cold motor, nominal voltage and frequency, and sheets fed centrally and lengthwise at 90 degrees. Paper properties also affect results (page 2).
Where can I use the shredder?
In closed spaces at 10 °C to 25 °C (50 °F to 77 °F) and 15% to 95% non-condensing humidity, upright, with a 100 mm gap to the wall (page 2).
Why did the shredder switch off by itself?
It switches off automatically to cool down after long use or overload, and also when the housing is open (page 3).
Should I remove staples and paper clips?
Yes, remove paper clips and staples before shredding (page 3).
