Page 1 of 16
Page 2 of 16
Text on page 3
The following conditions apply to the performance in terms of sheets listed under technical data:
IMPORTANT!
Read the operating and safety instructions BEFORE placing the document shredder into operation. You must follow the instructions. Keep the operating instructions in a safe place ready for later use.
Maximum number of sheets that are shredded in one pass under the following conditions: New cutting rollers, oiled if needed, cold motor, power supply with nominal voltage and nominal frequency (230 V/50 Hz; 120 V/60 Hz). Deviations may result in reduced sheet processing and increased operating noises. The sheets are fed centrally and lengthwise at a 90 degree angle. The performance in terms of sheets can also vary depending on the paper properties and input.
Table of Contents Important information . . . . . . . . . . . . . . . 6 1.4 Scope of supply . . . . . . . . . . . . . . . . . . 60 1.5 Technical specifications . . . . . . . . . . . . . 60 Operation . . . . . . . . . . . . . . . . . . . . . . 61 2.4 Paper shredding . . . . . . . . . . . . . . . . . 62 2.10 CD, DVD & card shredding . . . . . . . . . . . . 64 Maintenance / troubleshooting . . . . . . . . 66 3.1 Emptying shredding waste . . . . . . . . . . . . 66 3.4 Overheated . . . . . . . . . . . . . . . . . . . . . . 67 3.5 Overload . . . . . . . . . . . . . . . . . . . . . . . . 67 3.15 Cleaning the shredder . . . . . . . . . . . . . . . 70
- Do not place the device near a source of heat.
- Store, transport and operate the device in an upright position only.
- Only use liquids and gases on the device that comply with DAHLE guidelines.
- Do not open up the device.
- Only operate the device in closed spaces, at temperatures of between 10 °C and 25 °C (50 °F to 77 °F) and at a non-condensing humidity of between 15% and 95%.
- Ensure that the building installation has shortcircuit protection: max. 16 A (US max. 20 A).
- Do not operate the document shredder without inserting documents.
- The device is not intended for use by persons (including children) with restricted physical, sensory or mental capabilities or a lack of experience and knowledge, unless they are working under supervision or receive detailed instruction about how to use the device from a person who is responsible for safety.
The document shredder is intended to be used for shredding paper. Depending on the model variant, a small amount of the following materials can also be shredded:
- CDs/DVDs, bank cards and credit cards (see technical data).
- The normal staples and paper clips found in paper documents (exception: security level P6 and P7 devices).
Wear, damage due to improper use or unauthorised modifications and repairs are not covered by the warranty or the guarantee.
Dispose of the document shredder properly in an environmentally friendly way at an authorised collection point. Do not dispose of any parts of the document shredder or packaging in domestic waste.
The document shredder was designed for private use and for use in normal office environments.
Page 3 of 16
Text on page 4
Technical specifications - Subject to technical modifications.
Noise level when operated without shredding documents
WARNING
Do not use near caustic substances.
Place the device in a stable position on the floor, leaving a gap of 100 mm to the wall, ensure no heat can accumulate, engage brake mechanisms (depending on type) Do not use near inflammable liquids or gases.
The power plug is used to disconnect the power supply.
The mains socket must be easily accessible at all times.
Do not expose to moisture
This document shredder is not intended to be used by children (the product is not a toy).
Document shredder on standby
Do not touch the paper feed with your hands.
Document shredder in operation
Do not allow items of clothing to come into contact with the paper feed.
Do not allow your hair to come into contact with the paper feed.
The document shredder will switch off automatically to cool down if used for a long time and /or if overloaded
Keep spray cans away from the device.
Maintenance instructions / troubleshooting
Remove paper clips and staples before shredding.
Do not insert any diskettes.
Always wear safety goggles when destroying CDs/DVDs! Disconnect the document shredder from the electrical power supply before performing maintenance work.
Automatic switch-off when housing is open
Page 4 of 16
Text on page 5
351 ATIC
edM Shr
Wir erkläre Sicherh stimmt üb gemäß d
iniger Verantwortlichkeit, dass der DAHLE Aktenvernichter* den einschlägigen esundheitsanforderungen der EG-Produktsicherheitsrichtlinie** entspricht. Das Gerät en folgenden harmonisierten Normen*** und Spezifikationen****, ngen der Richtlinien*****. Ausgabe******.
2,4m/min
max.120
DIN 66399 0-0
US letter
20 lb max.120
220 - 240 V / 50 - 60 Hz 110 - 120 V / 50 - 60 Hz
2,4m/min
US letter
20 lb max.9
dM
3 x 9 mm
DIN 66399 T-5 / E-4
DIN 66399 P-4 / F-2
x. ma m m 220 6“ 8.6
585 mm 23.03“
≤62 dB (A)
mm “ 3 14.8
28 l / 7.4 gal
14,7 kg 32.5 lbs
Page 5 of 16
Page 6 of 16
Text on page 7
DIN A 80 g 4 /m 2 max.
US le tter 20 lb max.
Page 7 of 16
Text on page 8
DIN A 80 g 4 /m 2 max.1
US le tter 20 lb max.
Page 8 of 16
Text on page 9
CD/DVD
Page 9 of 16
Text on page 10
Credit card
351 ATIC
edM Shr
MyBinding.com 5500 NE Moore Court Hillsboro, OR 97124 Toll Free: 1-800-944-4573 Local: 503-640-5920
Page 10 of 16
Text on page 11
512 IC
3 AT
edM Shr
351 ATIC
edM Shr
Page 11 of 16
Text on page 12
351 ATIC
351 ATIC
edM Shr
edM Shr
35 ATIC
edM Shr
3 Sek.
351 ATIC
Sh
M red
Page 12 of 16
Text on page 13
351 ATIC
edM Shr
3 Sek.
351 ATIC
edM Shr
351 ATIC
edM Shr
Page 13 of 16
Text on page 14
351 ATIC
351 ATIC
edM Shr
edM Shr
351 ATIC
edM Shr
351 ATIC
edM Shr
351 ATIC
edM Shr
Page 14 of 16
Page 15 of 16
Page 16 of 16 ยท End of manual
Frequently asked questions
Under what conditions is the rated sheet capacity measured?
New cutting rollers, oiled if needed, a cold motor, nominal voltage and frequency, and sheets fed centrally and lengthwise at 90 degrees. Paper properties also affect results (page 3).
Where can I use the shredder?
In closed spaces at 10 °C to 25 °C (50 °F to 77 °F) and 15% to 95% non-condensing humidity, upright, with a 100 mm gap to the wall (page 3).
Why did the shredder switch off by itself?
It switches off automatically to cool down after long use or overload, and also when the housing is open (page 4).
Should I remove staples and paper clips?
Yes, remove paper clips and staples before shredding (page 4).
