Drytac Banner Bug Assembly Instructions, page 1
Text on page 1

Assembly Instructions

  1. Remove the base and folded support rod, which features shock cord tubes similar to those found in camping tent poles.
  2. Straighten out the rod so it becomes one long pole, inserting the smaller, darker portions of each section into the hole of another section. The top portion of the support rod is the same diameter as the rest of the pole. The bottom portion of the support rod narrows at the end and has a bright aluminum ring. Insert the bottom portion into the hole in the base of the Banner Bug ® .
  3. Gently raise the banner from the retractable base until it is the same height as the support rod.
  4. Attach the banner to the rod by inserting the black, plastic hook attached to the top rail into the top of the pole.

NOTE: If you want to shorten your banner stand, do not connect the top portion of the shock cord rod and leave it hanging. Instead, attach the banner to the second highest rod by inserting the black, plastic hook attached to the top rail into the top of that part of the pole.

WWW.MYBINDING.COM

Rev May 2014

For tall systems, it is easier to attach and detach the banner from the rod by tilting the banner stand or laying it on a table.

Page 1 of 1 · End of manual

Quick start

  1. Remove the base and the folded shock-cord support rod.
  2. Join the rod sections into one pole by inserting the smaller, darker end of each section into the next.
  3. Insert the bottom section, which narrows and has a bright aluminum ring, into the hole in the base.
  4. Gently raise the banner from the retractable base to the height of the rod.
  5. Insert the black plastic hook on the top rail into the top of the pole.

Frequently asked questions

How do I make the Banner Bug shorter?

Leave the top section of the shock-cord rod unconnected and hanging, and hook the banner into the top of the second-highest section. See page 1.

Which end of the pole goes into the base?

The bottom section, which narrows at the end and has a bright aluminum ring. See page 1.

Is there an easier way to attach the banner on tall stands?

Yes. Tilt the stand or lay it on a table to attach or detach the banner from the rod. See page 1.