Drytac Banner Bug Graphic Replacement Instructions, page 1
Text on page 1
  1. Release the graphic panel completely from the system to expose the PVC tongue and graphic join. Place the pin into the side of the unit when the hole on the roller lines up with the hole in the end cap.
  2. Carefully remove the existing graphic panel from the PVC tongue. Add 0.78” (20mm) hook tape (male) to the base of the new graphic panel and then place in the same position.
  3. Slide the top rail off the old graphic panel and carefully remove the grey PVC strip (female loop attached) from the print.
  4. Add 0.63” (16mm) hook tape (male) to the top of the new graphic panel and apply the existing grey PVC strip.
  5. Fold the top of the new graphic backwards once and then slide into the top rail.
  6. While carefully holding the graphic, remove the pin from the side of the system and gently allow the graphic to roll back into the unit.

WWW.MYBINDING.COM

Rev May 2014

Graphic Replacement Instructions

Page 1 of 1 · End of manual

Quick start

  1. Pull the graphic fully out to expose the PVC tongue and join, and insert the pin in the side when the roller and end cap holes line up.
  2. Remove the old graphic from the PVC tongue, add 0.78" (20 mm) hook tape to the base of the new graphic and fit it in the same position.
  3. Slide the top rail off the old graphic and remove the grey PVC strip.
  4. Add 0.63" (16 mm) hook tape to the top of the new graphic and apply the grey PVC strip.
  5. Fold the top of the new graphic back once and slide it into the top rail.
  6. Hold the graphic, remove the pin and let the graphic roll gently back into the unit.

Frequently asked questions

What hook tape do I need for a replacement Banner Bug graphic?

0.78" (20 mm) hook tape for the base of the graphic and 0.63" (16 mm) hook tape for the top. See page 1.

How do I stop the roller retracting while I change the graphic?

Insert the pin into the side of the unit when the hole on the roller lines up with the hole in the end cap. See page 1.