Drytac Banner Bug Retensioning Instructions, page 1
Text on page 1
  1. With the system facing you, remove the left hand end cap using a Phillips head screwdriver to expose the reel (with leader strip protruding out of the system).

WARNING:

Take care when removing the end cap. The reel may not be completely unwound and may cause the end cap to spin quickly.

  1. Place the pin into the right-hand end cap. Rotate the reel until the hole in the reel lines up with the hole in the end cap. Place the Allen key to stop the reel from rotating.
  2. Position the left-hand end plate onto the system so that the fl at metal bar of the reel protrudes from the slot in the end cap. Grip the fl at bar with a vice grip.
  3. Rotate the fl at bar clockwise. The table above indicates the number of rotations required for different size BannerBug ® models.
  4. Replace the screws in the left-hand end cap.

WWW.MYBINDING.COM

Rev May 2014

Re-Tensioning Instructions

Page 1 of 1 · End of manual

Quick start

  1. With the stand facing you, remove the left-hand end cap with a Phillips screwdriver. Take care, as the reel may spin.
  2. Put the pin into the right-hand end cap, line up the reel and end cap holes, and use the Allen key to stop the reel turning.
  3. Fit the left-hand end plate so the reel's flat metal bar sticks out of the slot, and grip the bar with a vice grip.
  4. Rotate the flat bar clockwise the number of turns listed for your Banner Bug size.
  5. Replace the screws in the left-hand end cap.

Frequently asked questions

What tools do I need to re-tension a Banner Bug?

A Phillips screwdriver, the pin, an Allen key and a vice grip. See page 1.

Which way do I turn the reel to add tension?

Rotate the flat bar clockwise. See page 1.