Drytac The Grand Stand Installation Instructions

It is stored underneath the base. See page 1 .

Text on page 1

The GrandStand

Get the hex key from underneath the base.
Remove the hex screws on both sides with the hex key.
Open the lid and remove the graphic roller.
Pull out the panel strip from the graphic roller.
Remove the liner on the front tape and press the graphic on the panel strip. Do the same to the top panel strip (squarely).
Insert the bottom panel strip back into the graphic roller.
Insert the top panel strip into the top profile. With a piece of clear tape on the back, center and secure the graphic to keep it from sliding.
Put the graphic roller back into the base and secure the lid on both sides with the hex key.
Pull out the locking key and roll the graphic slowly into the base. Gently hold on to the graphic to keep it from retracting too quickly.
Insert the pole into the base.
Pull out the graphic from the base and keep one foot on the base to prevent it from pulling up.
Insert the top into the top profile. Installation is now complete.

Page 1 of 1 · End of manual

Take the hex key from under the base, remove the hex screws on both sides, open the lid and lift out the graphic roller.
Pull out the panel strip, remove the tape liner and press the graphic squarely onto it. Do the same with the top panel strip.
Insert the bottom strip back into the roller and the top strip into the top profile, securing the graphic with clear tape on the back.
Replace the roller, secure the lid with the hex key, pull the locking key and slowly roll the graphic into the base.
Insert the pole, pull the graphic up with one foot on the base, and fit the top profile onto the pole.

Where is the hex key for The GrandStand?

It is stored underneath the base. See page 1.

How do I stop the graphic retracting too fast?

Hold the graphic gently as it rolls into the base after you pull out the locking key. See page 1.