Fellowes Microshred MS-460CS Micro Shred Paper Shredder Instruction Manual, page 1

Page 1 of 3

Fellowes Microshred MS-460CS Micro Shred Paper Shredder Instruction Manual, page 2
Text on page 2

Help Line

Fellowes

www.fellowes.com

MS-460Cs

Please read these instructions before use.

© 2008 Fellowes, Inc. Part No. 402763 REV E

Page 2 of 3

Fellowes Microshred MS-460CS Micro Shred Paper Shredder Instruction Manual, page 3
Text on page 3

ENGLIS

ENGL E EN

ENGLISH ENGLI

ENG

N GLISH

NG

Model MS-460C

MS-460Cs

SafeSense ® Technology Shredder head

See safety instructions below

OPERATION

Disconnect Power Switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.

PAPER

SafeSense ® override switch

Press Auto-On ( )

Continuous operation: 10-12-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 10-12-minutes will trigger a cool down period to resume operation.

Set to ( ) and plug in

Feed into paper entry and release

Set to Off ( ) and unplug

CARD/CD/3.5 DISK

Press Auto-On ( )

Hold card/CD/ 3.5 disk at edge

Feed into card/CD/3.5 disk entry and release

TROUBLESHOOTING

Paper jam: Set to Off ( ) and empty bin. Replace bin and follow any or all of the below procedures.

Indicator lights:

Yellow - SafeSense ® active

Yellow flashing - SafeSense ® not active

Breakthrough Safety Technology! SafeSense stops shredding when hands are too close to the opening.

Press and hold Reverse ( )

To Test SafeSense ® Technology

Press Auto-On ( )

CAPABILITIES

  • Paper clip shredding is not recommended for this shredder.

Maximum: Sheets per pass (Confetti-Cut).............................................................................10* Cards/CDs per pass............................................................................................... 1 Paper width ......................................................................................8.75”/222mm Card/CD width.......................................................................................5”/125mm Continuous operation ........................................................................ 10-12 minutes

  • 20lb., 8.5”x11” (75g) paper at 120v, 60 Hz, MS-460Cs–5.8Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 50-100 paper passes; 25 cards; 5 CDs/3.5 disks.

Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

  • Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.
  • Keep foreign objects – gloves, jewelry, clothing, hair, etc.
  • away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.
  • Never use aerosol, petroleum based or other flammable products on or near shredder. Do not use canned air on shredder.
  • Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.
  • 10 sheets per pass to avoid jams.
  • Avoid touching exposed blades under Confetti-Cut shredder head.
  • Use only designated entry for cards/CDs/3.5 disks. Keep finger away from CD hole.
  • The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.
  • Paper and Card/CD/3.5 disks cannot be shredded at the same time.

Set to Off ( and unplug )

Will shred: P aper, credit cards, CD/DVDs/3.5 disks and staples

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips,* laminates or plastic other than noted above Paper shred size: Confetti-Cut.................................................................... 5/64” x 5/16” (2 x 8mm) Card/CD shred size: Strip-Cut ............................................................................................ 5/16” (8mm)

Alternate slowly back and forth

ATTENTION: If the SafeSense ® light remains on, you must engage the (See SafeSense ® instructions below.)

Gently pull uncut paper from paper entry. Plug in.

Press and hold Reverse ( )

Make sure bin is pushed in

Wait for motor to cool down

Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense ® feature.

SafeSense ® paper jam: If the SafeSense ® feature activates (SafeSense ® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense ® feature and clear the paper. Warning – when switch is in override position, the SafeSense ® light will flash and the SafeSense ® feature will NOT function. Once the paper is cleared, reset the SafeSense ® feature.

Sensor light illuminated–paper jammed

SafeSense ® override switch

MAINTENANCE

Run regularly in reverse for one minute

Oil when bin is full, or immediately, if:

  • Capacity decreases
  • Motor sounds different, or Shredder stops running

Follow oiling procedure below and repeat twice.

  • Apply oil across entry

Press and hold Reverse ( ) 2-3 seconds

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 7 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

Page 3 of 3 · End of manual

Quick start

  1. Make sure the disconnect power switch is in the ON (I) position. Insert a waste bag (Fellowes #36052) for easy disposal.
  2. Plug the shredder in and press Auto-On.
  3. Feed paper into the paper entry and release. Feed no more than 10 sheets per pass.
  4. For a card or CD/3.5 disk, hold it at the edge, feed it into the card/CD entry and release. Paper and cards/CDs cannot be shredded at the same time.
  5. Run no longer than 10-12 minutes continuously; going beyond this triggers a cool-down period.
  6. When finished, set to Off and unplug.

Troubleshooting

ProblemLikely causeFix (from the manual)
Paper jamToo much paper fed at onceSet to Off and empty the bin. Replace the bin, press and hold Reverse, then gently pull uncut paper from the paper entry. Alternate slowly back and forth if needed. Page 3
Shredder doesn't startBin not fully in place, or the motor has overheatedMake sure the bin is pushed in. If the overheat light is on, wait for the motor to cool down. Page 3
SafeSense light stays on and the shredder seems jammed when it is notThe SafeSense feature has activatedUse the SafeSense override switch to deactivate the feature and clear the paper. The light flashes and SafeSense does NOT work while in override, so reset it once the paper is cleared. Page 3
Capacity decreases, motor sounds different or shredder stopsCutters need oilApply non-aerosol vegetable oil across the entry, press and hold Reverse for 2-3 seconds, and repeat twice. Page 3

Frequently asked questions

How many sheets can the MS-460Cs shred at once?

Up to 10 sheets of 20 lb, 8.5" x 11" paper per pass, and one card or CD per pass. Recommended daily use is 50-100 paper passes, 25 cards and 5 CDs/3.5" disks. See page 3.

What size are the shred particles?

Paper is confetti-cut to 5/64" x 5/16" (2 x 8mm). Cards and CDs are strip-cut to 5/16" (8mm).

What can't it shred?

Continuous forms, adhesive labels, transparencies, newspaper, cardboard, laminates and plastic other than cards/CDs. Paper clip shredding is not recommended.

How often should I oil the shredder?

Oil it when the bin is full, or right away if capacity drops, the motor sounds different or it stops running. Also run it in reverse for one minute regularly.

What is the warranty?

The cutting blades are warranted for 7 years and all other parts for 1 year from the date of purchase by the original consumer.