POWERSHRED 99Ms

Please read these instructions before use. Do not discard: keep for future reference.

Quality Office Products Since 1917

ENGLISH

Model 99Ms

KEY

A. SafeSense ® Technology

B. Paper entry

C. See safety instructions

D. Pullout bin

E. Casters

F. Disconnect power switch

1. OFF

2. ON

G. Control Panel and LEDs

1. Overheat (red)

2. Bin open (red)

3. Bin full (red)

4. Remove Paper (red)

5. SafeSense ® indicator (yellow)

6. Reverse

7. ON/OFF (blue)

8. Forward

CAPABILITIES

Will shred: Paper, credit cards and staples

Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard, paper clips, CD/DVDs, laminates, file folders, X-rays or plastic other than noted above

Paper shred size: Micro-Cut .......................................................................................................... 2 x 14mm

Maximum: Sheets per pass ........................................................................................................... 12* Paper entry width .................................................................................................. 230mm

• A4 (70g), paper at 220V-240V, 50/60 Hz, 3.4Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 1000 sheets per day, 50 credit cards. 12 sheets per pass to avoid jams.

Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

t 0QFSBUJPO NBJOUFOBODF BOETFSWJDFSFRVJSFNFOUTBSFDPWFSFEJOUIFJOTUSVDUJPO manual. Read the entire instruction manual before operating shredders.

t ,FFQBXBZGSPNDIJMESFOBOEQFUT,FFQIBOETBXBZGSPNQBQFSFOUSZ"MXBZTTFU to off or unplug when not in use.

t ,FFQGPSFJHOPCKFDUToHMPWFT KFXFMSZ DMPUIJOH IBJS FUDoBXBZGSPNTISFEEFS openings. If object enters top opening, switch to Reverse ( ) to back out object.

t 5IJTTISFEEFSIBTB%JTDPOOFDU1PXFS4XJUDI ' UIBUNVTUCFJOUIF0/( ) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.

t /FWFSVTFBFSPTPMQSPEVDUT QFUSPMFVNCBTFEMVCSJDBOUTPSPUIFSGMBNNBCMF products on or near shredder. Do not use canned air on shredder.

t 4ISFEEFSNVTUCFQMVHHFEJOUPBQSPQFSMZHSPVOEFEXBMMPVUMFUPSTPDLFUPGUIF voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.

t %POPUVTFJGEBNBHFEPSEFGFDUJWF%POPUEJTBTTFNCMFTISFEEFS Do not place near or over heat source or water.

BASIC SHREDDING OPERATION

PAPER OR CARD

Continuous operation: Up to 15-minutes maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 15-minutes will trigger 25-minute cool down period.

Plug in and put disconnect power switch in ON (I) position

Press ON ( ) to activate (blue)

Feed paper/card straight into paper entry and release

When finished shredding set to OFF ( )

ADVANCED PRODUCT FEATURES

Patented SafeSense ® Technology Stops shredding immediately when hands touch the paper opening.

SilentShred™ Technology SilentShred™ noise quality shreds without noisy disruptions.

Sleep Mode Energy saving feature shuts down automatically after 2 minutes of no shredding activity

SAFESENSE ® TECHNOLOGY OPERATION

SLEEP MODE OPERATION

Stops shredding immediately when hands touch the paper opening.

Energy saving feature shuts down the shredder after 2 minutes of inactivity

SET-UP AND TESTING

WHEN IN SLEEP MODE

Touch test area and Turn the shredder ON ( ) to activate SafeSense ® look for the SafeSense ® indicator to illuminate

SafeSense ® is active and working properly

If hand is held on SafeSense ® area more than 3 seconds, shredder will shut off

To get out of sleep mode touch control panel

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER

CLEANING AUTO-START INFRARED SENSORS

All micro-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry) .

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

TO CLEAN THE SENSORS

• Apply oil across entry

Press and hold forward ( ) 2-3 seconds

Turn off and unplug shredder

Locate Auto-start infared sensor

Dip cotton swab in rubbing alcohol

Using cotton swab, wipe away any contamination from the paper sensors

• Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.

Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053.

Remove Paper: When illuminated, press reverse (

) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.

SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense ® indicator will illuminate and the shredder will stop shredding. If SafeSense ® is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.

POWERSHRED 99Ms

Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the product Model 99Ms conforms with the requirements of the Restriction of Hazardous Substances Directive (2011/65/EU), the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC), the WEEE directive (2002/96/EC), and below harmonized European EN Standards:

EMC Standard:

Itasca, Illinois, USA March 1, 2013

This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive.

For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE

LIMITED PRODUCT WARRANTY

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any

additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

Australia Residents Only: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.

Questions or Concerns?

Troubleshooting Registration Manuals

Troubleshooting Replacement parts General questions

©2013 Fellowes, Inc. Part No. 407307 Rev C

Customer Service & Support