www.fellowes.com

© 2009 Fellowes, Inc. Part No. 403109 REV C

ENGLISH

Model P-58Cs

OPERATION

Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.

SafeSense Technology Shredder head Sheet capacity icon

PAPER

See safety instructions below

LED Lights Standby (green)

Auto-On (I) Off (O) Reverse (R)

Window Bin

Continuous operation: 3-5 minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 3-5 minutes will trigger 15-minute cool down period.

Set to Off (O) and plug in

Feed into paper entry and release

Set to Auto-On (l)

CARD

Set to Auto-On (l)

Feed into center of entry and release

Hold card at edge

TROUBLESHOOTING

SafeSense ® Override Switch

Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.

Indicator lights:

Yellow - SafeSense ® active

Yellow flashing - SafeSense ® not active

Breakthrough Safety Technology! SafeSense ® stops shredding when hands are too close to the opening.

Make sure head is on basket correctly

To Test SafeSense ® Technology

Set to Reverse (R) for 2-3 seconds

Alternate slowly back and forth

CAPABILITIES

Will shred: Paper, credit cards, staples Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips, laminates or plastic other than noted above Paper shred size: Cross-Cut......................................................................... 5/32” x 2” (3.9 x 50mm)

Maximum: Sheets per pass....................................................................................................9* Cards per pass......................................................................................................1* Paper width...................................................................................8 3/4” (225mm) Continuous operation............................................................................. 3-5 minutes

• 20 lb., 8.5”x11” paper at 120v, 60Hz, 3.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates:

10-20 paper passes; 10 cards.

Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.
• Never use aerosol, petroleum-based or other flammable products on or near shredder. Do not use canned air on shredder.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc.– away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.
• Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.
• Avoid touching exposed blades under Cross-Cut shredder head.
• 9 sheets per pass to avoid jams.
• The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.

Gently pull uncut paper from paper entry. Plug in.

Set to Off (O) and unplug

ATTENTION: If the SafeSense ® light remains on, you must engage the SafeSense ® feature. (See SafeSense ® instructions below.)

Set to Off (O) and unplug

Wait 15 minutes for motor to cool down

Set to Reverse (R)

Remove and empty basket

Override Switch in order to perform steps above. Once the jam is cleared, reset the

SafeSense ® paper jam: If the SafeSense ® feature activates (SafeSense ® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense ® feature and clear the paper. Warning – when switch is in override position, the SafeSense ® light will flash and the SafeSense ® feature will NOT function. Once the paper is cleared, reset the SafeSense ® feature.

Sensor light illuminated–paper jammed

SafeSense ® override switch

MAINTENANCE

Run regularly in reverse for one minute

Oil when bin is full, or immediately, if:

• Capacity decreases
• Motor sounds different, or Shredder stops running

Follow oiling procedure below and repeat twice.

Set to Off (O)

Set to Auto-On (I) Shred one sheet

• Apply oil across entry
• Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

Set to Reverse (R) 2-3 seconds

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY defects in material and workmanship for 5 years from the date of purchase by the original consumer. LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 Fellowes be liable for any consequential or incidental damages attributable to this product. year from the date of purchase by the original consumer. If any part is found to be defective during the This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer. expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED