Help Line

Help Line

Fellowes

Fellowes

Canada Benelux

Canada Deutschland

France Deutschland

United Canada

States

Korea Korea

Malaysia Malaysia

Polska Polska

United United

Kingdom States

www.fellowes.com

PS-12Cs

Please read these instructions before use.

© 2008 Fellowes, Inc. Part No. 403850

© 2006 Fellowes, Inc. Part No. 401926

ENGLISH

OPERATION

Model PS-12Cs

PAPER

SafeSense ® override switch

See safety instructions below

SafeSense ® Technology (yellow)

Auto-On ( I )

Continuous operation: 4-5 minutes maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5-minutes will trigger 20-minute cool down period.

Press Auto-On ( I )

Set to Off (O)

Feed into paper entry and release

CARD

Press Auto-On ( I )

Hold credit card at edge

Feed into center of entry and release

TROUBLESHOOTING

Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.

Shredder doesn’t start:

Yellow - SafeSense ® active

Yellow flashing - SafeSense ® not active

Make sure control switch is in Auto-On ( I ) position

Breakthrough Safety Technology! SafeSense ® stops shredding when hands are too close to the opening.

To Test SafeSense ® Technology

Set to Reverse (R)

Shredder comes fully assembled. Remove basket packing material and plug in. Disconnect power switch must be in ON (I) position to operate shredder.

Press Auto-On ( I )

ATTENTION: If the SafeSense ® light remains on, you must engage the SafeSense ® feature. (See SafeSense ® instructions below.)

CAPABILITIES

Maximum: Sheets per pass (Cross-Cut).................................................................................12* Cards per pass...................................................................................................... 1 Paper width.................................................................................. 9 inches/229mm Continuous operation............................................................................ 4-5 minutes

• 20 lb., 8.5 inches x 11 inches paper at 120v, 60 Hz, 5.0Amps; heavier paper, humidity or other than rated voltage may reduce capacity.

Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc.
• away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.
• Never use aerosol, petroleum based or other flammable products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.
• 12 sheets per pass to avoid jams.
• Avoid touching exposed blades under Cross-Cut shredder head.

Set to Off (0)

Pull uncut paper from paper entry

Wait 20 minutes for red light to turn off

Set to Reverse (R)

Will shred: Paper, small paper clips, credit cards and staples Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than noted above Paper shred size: Cross-Cut................................................. 5/32 inches x 2 inches (3.9mm x 50mm)

Alternate slowly back and forth

• The socket-outlet shall be installed near the equipment and shall be easily accessible.

Override Switch in order to perform steps above. Once the jam is cleared, reset the

SafeSense ® paper jam: If the SafeSense ® feature activates (SafeSense ® light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense ® feature and clear the paper. Warning – when switch is in override position, the SafeSense ® light will flash and the SafeSense ® feature will NOT function. Once the paper is cleared, reset the SafeSense ® feature.

Sensor light illuminated–paper jammed

SafeSense ® override switch

MAINTENANCE

Run regularly in reverse for one minute

Oil when bin is full, or immediately, if:

• Capacity decreases
• Motor sounds different, or shredder stops running

Follow oiling procedure below and repeat twice.

Set to Off (0)

• Apply oil across entry

Press Auto-On ( I )

Set to Reverse (R) 2-3 seconds

• Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

WARRANTY, INCLUDING THAT OF MERCHANTABILITY

OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.