

Page 1 of 8

Page 2 of 8

Page 3 of 8

Page 4 of 8

Page 5 of 8

Page 6 of 8

Page 7 of 8

Page 8 of 8 · End of manual
Quick start
- Turn it on: Press the ON button. The wait light shows warm-up, and the ready light comes on when the machine can bind.
- Insert the bottom strip: Put the strip with holes in the strip recess, textured side down, with its small hole over the locating pin.
- Place the document: Put the punched document face up on the bind platen. Rest its punched edge on the backstop and its left edge by the bind edge guide.
- Add covers: The maximum binding capacity is 3 inches. Bind soft covers in with the document. For hard covers, bind in the VeloBind endsheets.
- Add the top strip: Press the pin strip down firmly through the holes until it meets the top sheet.
- Pick a bind mode: Press the standard bind button for maximum strength or the fast bind button for a cycle half as long.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Holes do not line up with the strip | The bind edge guide is not adjusted correctly. | Adjust it so the punched holes align with the strip holes and the left edge rests against the guide. Page 4 |
| Bottom strip sits wrongly | The small hole is not on the locating pin. | Fit the small hole over the pin so the hole nearest the left end aligns with the backstop line. Page 4 |
| Tray ajar light is on | The debris tray is not inserted properly. | Reseat the debris tray in the base. Empty it often. Page 5 |
| Debinding does not start | Machine is not in debind mode or the document is misplaced. | Place the bound edge against the backstop, strip hole over the pin, and press the Debind button before lowering the pressure bar. Page 3 |
| Machine will not return to binding after debinding | Mode still set to debind. | Press the standard bind or fast bind button. Page 3 |
Frequently asked questions
What is the maximum binding capacity?
The maximum capacity is 3 inches. See page 4.
How do I debind a document?
Position it against the backstop with the strip hole over the locating pin, press Debind, then lower the pressure bar. Remove it and peel off the top strip when the bar rises. See page 3.
What is the difference between standard and fast bind?
Standard bind gives maximum binding strength. Fast bind cuts the cycle in half. See page 5.
How long does debinding take?
The bar raises after approximately 25 seconds. See page 3.
What does the tray ajar light mean?
The debris tray is not inserted correctly in the machine base. See page 5.
