Page 1 of 2
Text on page 2
Harmony Premium Glass Markerboards
Mounting Instructions
For the most secure mounting, the board should be attached directly into wall studs. Ghent has supplied self-tapping screws for mounting into wooded wall studs and toggle anchors when wall studs cannot be used.
boards 4'x6' or larger will include 6 standoffs.
We also recommend at least three people install the board.
Install the board with the frosted/painted side facing the wall.
1.) Place the board up against the wall, at the desired height, and level the board. Using the holes in the board as a template, mark the drilling locations on the wall. Set the board aside.
2.) Insert a self-tapping screw, or toggle anchor, into each standoff.
3.) Drill 3/32" (2MM) holes for the self-tapping screws, or 7/16" (11MM) holes for the toggle anchors at the marked locations on the wall.
4.) Attached the stand-offs to the wall via the self-tapping screw, or toggle anchors.
5.) Clean both sides of the board.
6.) Install the stand-off caps and the plastic washers into the board as shown.
7.) Place the marker/eraser holder over the bottom right hand stand-off.
8.) Lift the board and align the stand-off caps with the mounted stand-offs. Swing the marker/eraser holder up into the position shown and firmly screw the caps into the stand-offs.
Plastic Flat Washer
Plastic Shoulder Washer
Stand-off cap
Board (Frosted/painted Side To The Wall)
9.) Complete the assembly by loading the markers and eraser into the marker/eraser holder as shown.
(Note: Not all Harmony Premium Glass boards come with the pictured hardware).
MyBinding.com 5500 NE Moore Court Hillsboro, OR 97124 Toll Free: 1-800-944-4573 Local: 503-640-5920
Self-Tapping Screw (Or Toggle Anchor)
Marker/Eraser Holder (see note 9)
IS-HMY 11/14
Page 2 of 2 · End of manual
Quick start
- Hold the board level against the wall at the desired height and mark the drilling locations through its holes. Set the board aside.
- Insert a self-tapping screw or toggle anchor into each standoff.
- Drill 3/32" (2 mm) holes for self-tapping screws or 7/16" (11 mm) holes for toggle anchors, then attach the standoffs to the wall.
- Clean both sides of the board and install the standoff caps and plastic washers.
- Place the marker/eraser holder over the bottom right standoff.
- Lift the board with the frosted/painted side to the wall, align the caps with the standoffs and screw them in firmly.
- Load the markers and eraser into the holder.
Frequently asked questions
Which side of the glass faces the wall?
The frosted/painted side faces the wall (page 2).
How many standoffs does the board use?
Boards 4' x 6' or larger include 6 standoffs (page 2).
Is mounting hardware included?
Ghent supplies self-tapping screws for wood studs and toggle anchors for walls without studs. Ghent recommends at least three people for installation (page 2).
