Ghent PA33672K Installation Instructions, page 1
Text on page 1

Ghent 36" x 72'3-Do0r Enclosed Natural Cork Bulletin Board with Satin Aluminum Frame

Provided by

My Binding

Page 1 of 2

Ghent PA33672K Installation Instructions, page 2
Text on page 2

Your Message Center is designed for mounting on most wall surfaces. Because of the wide variation of mounting surface construction, specific mounting hardware is not included. For the most secure mounting, use #10 wood screws installed directly to wooden wall studs. When wall studs can not be used, we recommend using expandable type wall anchors available at you local hardware center. 7/01

Hanging the Message Center

  1. Determine the desired mounting height of the unit. The recommended height is 78" from top of unit to floor.
  2. Scribe a level line 1-1/2" down from this location.
  3. Position and mark the locations for (2) mounting holes per the chart below.

Nominal Unit Width-

  • TOPOFUNIT

Distance Between

Mounting Hole Centers

36" 72" 18" 48"

Nominal Unit Width

Distance Between

Mounting Hole 14-13/16"20-13/16"26-13/16" 32-13/16"43-15/16" 55-15/16"67-1/16"

Centers

Tomount the Message Centerusing#i0wood screws intostuds...

4a. Drill (2) 3/32" diameter holes at the mounting hole locations. Install screws, allowing the screw heads to protrude approximately 1/4" maximum from the wall. To mount the Message Center using expandable wall anchors..

4b. Drill and install (2) anchor mounting holes at the mounting hole locations, per the anchor manufacturer's instructions. Adjust the screw heads so

5. Lift the Message Center hangers on to the screws.

Installing the Lamps

If your unit is a two or three door unit, connect the first lamp as instructed. Connect the first lamp to the second lamp by plugging one end

second lamp.

7. Snap the lamp(s) into the mounting clips that have been pre-installed in the top of the unit. Handle the lamps with care to avoid damaging them. 8. Secure the power cord to_ the right inside wall of the unit by inserting the cord into the pre-mounted cord clips.

9. Plug the power cord in a suitable 120 VAC outlet.

10. Turn the lamps on to insure they operate properly.

Concealed Bulb Message Center

Instruction Sheet Is-Cpa

Page 2 of 2 · End of manual