Assembly Hardware (Included)

4. 2 1/2" BLACK (4) 3/4" BLACK (2)_FLAT (2) BLACK (2) REVERSING BRACKET HEX HEAD SCREWS WASHER KNOBS FLAT HEAD SCREWS ROUNDHEAD SCREWS WITH STEM

• （1）REVERSIBLE BOARD FIG. #4

Step 1:Using(4）2 1/2"Black Hex Head

SCREWS,FASTEN THE LEGS TO THE CHALKRAIL,

Matching The Pre-Drilled Holes.(Fig. #1) Fig. #3

STEP 2:USING (4)1 1/2" ZINC FLAT HEAD SCREWS, (2） FLAT WASHERS ATTATCH THE 24"'BRACES TO THE LEGS AND CHALKRAIL,

Again Matching The Pre-Drilled Holes.(Fig #2)

Step 3:Using(4）3/4" Black Round Head Screws, Fig.#5

Attatch The Reversing Bracket To Both Sides Of

The Board, Using The Pre-Drilled Holes.(Fig. #3)

2. LEGS (1） CHALKRAIL

Step 4:To Place Board On Stand,Place One

Of The Reversing Bracket Stems Through The Hole

IN THE LEG. GENTLY GUIDE THE OTHER STEM THROUGH

The Hole In The Opposite Leg.(Fig. #4) Fig.#1

Step 5:To Complete,Place The Flat Washer Fig.#2

ON THE STEM OF THE REVERSING BRACKET, THEN SCREW

On The Black Knobs.(Fig. #5) (2)Braces

Reversible Board

InSTRUCTION SHEET ISRB8212G