Page 1 of 4
Text on page 2
3 Shelf Tuffy Cart Instructions
NOTICE:
Leg lengths of leg E may be shorter than leg F
- - Rubber Mallet
Optional fluted legs for units with cabinet pack
Install optional cabinet pack / pullout shelf / locking drawer assembly after step 1
Page 2 of 4
Text on page 3
Front Pullout Shelf Instructions
- - Phillips Screwdriver
Lay the top shelf of your Tuffy cart upside down and Install the four legs intended for this shelf.
Slide and align runner H & G onto the legs and tighten screw N with a screwdriver.
IMPORTANT:
Install optional side pullout shelf AFTER step 2
Take pullout shelf K and bracket L and screw together into the unfinished surface of shelf K with screw M.
Mount pullout shelf K to runner H & G so that the edge of the shelf snaps into the runner hooks.
You have now completed your pullout shelf.
Page 3 of 4
Text on page 4
Electric Assembly Instructions
Number of outlets may vary.
(Plastic or Metal Mounting Surface)
Push screw C through electric outlet A. Make sure the electric outlet A and cord wrap B align with the mounting surface screw holes. Push screw C through cord wrap B and the mounting surface screw holes. Use wing nut D and screwdriver to fasten.
Page 4 of 4 · End of manual
Quick start
- Have a rubber mallet and a Phillips screwdriver ready.
- Assemble the 3-shelf base cart, noting that leg E may be shorter than leg F.
- For the pullout shelf, lay the top shelf upside down and install the four legs intended for it.
- Slide runners H and G onto the legs and tighten screw N.
- Screw pullout shelf K to bracket L with screw M on the unfinished side, then snap the shelf edge into the runner hooks.
- Mount the electrical outlet and cord wrap to the mounting surface with screw C and wing nut D.
Frequently asked questions
What tools do I need?
A rubber mallet for the cart and a Phillips screwdriver for the pullout shelf (page 2, page 3).
Why is one set of legs shorter than the other?
That is expected: leg E may be shorter than leg F. Check which legs you are using for each shelf before assembling (page 2).
How is the front pullout shelf attached?
Runners H and G slide onto the top shelf's legs and are tightened with screw N. Shelf K is screwed to bracket L, then its edge snaps into the runner hooks. Install an optional side pullout shelf after step 2 (page 3).
How do I attach the electrical outlet?
Push screw C through the outlet and the cord wrap, line both up with the screw holes on the mounting surface, push the screw through, and fasten with wing nut D using a screwdriver. The number of outlets may vary (page 4).
