James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 1

Page 1 of 7

James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 2

Page 2 of 7

James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 3

Page 3 of 7

James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 4

Page 4 of 7

James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 5

Page 5 of 7

James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 6

Page 6 of 7

James Burn ProCrease-M2.1 Manual Creasing Machine User Manual, page 7

Page 7 of 7 · End of manual

Quick start

  1. Set it up: Put the machine on a suitable work platform with enough room around it. Make sure it sits stable.
  2. Unpack: Take the machine out of the package and take the operation handle out of the insert board.
  3. Install the handle: Pull the paper board backward until the handle hole shows. Fix the handle into the hole. Push it down softly, then pull the paper board up and out.
  4. Plan the crease: Decide where the crease goes first. For one crease, fix the right-side Slide Positioning Model at that spot.
  5. Two creases: Set the right-side model for the book spine crease first. Then set the left-side model for the reading crease.
  6. Place the paper: Put the paper in through the Mechanism core protection cover. Rest it against the back side of the fixed model.
  7. Crease: Push the operation handle down, hold it up, and take the paper out.

Troubleshooting

ProblemLikely causeFix (from the manual)
Crease is not in the right spotThe Slide Positioning Model was not pushed fully into place or its screws were not tightened.Push the head of the model to the needed position, then fix the screws by hand. Page 6
Positioning model or vernier is damagedThe model was moved while its head was on the vernier.Hold the head up and move the model straight and level. Do not move it while its head is on the vernier. Page 6
Machine is damaged or wears out earlyThe handle was pushed too hard.Push the handle down gently, not forcefully. Page 5
Two creases are not lining upThe book spine position was not set first.Set the right-side Slide Positioning Model for the book spine crease first. Then set the left-side model for the reading crease. Page 6

Frequently asked questions

How many people does it take to run the ProCrease-M2.1?

One operator is required when the machine is working. See page 5.

How do I set two creases on one sheet?

Set the right-side Slide Positioning Model for the book spine crease first. Then set the left-side model for the reading crease. See page 6.

What is the machine used for?

It is a manual creasing machine for covers and paper in offices, fast print shops, album making and packing production. See page 3.

How do I move the Slide Positioning Model safely?

Hold its head up and move it level. Do not move it while its head is on the vernier. See page 6.

Can I press the handle hard?

No. Pushing the handle strongly can damage the machine and shorten its life. See page 5.