Page 1 of 2
Text on page 2
- OPERATION INSTRUCTIONS
Clam Shell KF-772DH
- Insert the power plug into the socket. Check the voltage of the power socket.
- Push the switch to either the “HI” or “LO” setting based on the thickness of your clam shell. Allow the sealer to warm-up for 2-3 minutes.
- Place the clam shell edge between the sealing bars and hold down for one second. If the seal weld holds, continue in this manner.
If the welding appearance is broken or damaged, slide switch to “LO” position. If the welding appearance is incomplete, slide to “HI” position.
NOTE:
- Never touch the heated bars of the unit
- Never allow any liquid to come in contact with the unit
- Never shock or drop the unit
- Keep the sealing bars clean
- Always unplug the unit when not in use
- Allow the unit to cool down before putting away
18327 Sherman Way | Reseda, CA 91335 P: 818.705.0203 | F: 818.705.7893 contact@sealersales.com | www.sealersales.com
Page 2 of 2 · End of manual
Quick start
- Plug the sealer in, checking the socket voltage.
- Set the switch to HI or LO to suit the thickness of the clam shell and let it warm up for 2-3 minutes.
- Place the clam shell edge between the sealing bars and hold down for one second.
- Keep the sealing bars clean, unplug when not in use and let the unit cool before storing.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Seal looks broken or damaged | Heat too high | Slide the switch to LO. Page 2 |
| Seal looks incomplete | Heat too low | Slide the switch to HI. Page 2 |
Frequently asked questions
How long does the KF-772DH take to warm up?
2-3 minutes. See page 2.
How long do I hold the clam shell in the sealer?
Hold it down for one second; if the seal holds, continue the same way. See page 2.
Which heat setting should I use?
Choose HI or LO based on clam shell thickness; switch to LO if seals are damaged and to HI if they are incomplete. See page 2.
