Logan F60 Picture Framing Dust Cover Trimmer Manual, page 1

Page 1 of 2

Logan F60 Picture Framing Dust Cover Trimmer Manual, page 2
Text on page 2

Instruction Sheet

PICTURE FRAMING

DUST COVER TRIMMER

Operating Instructions

Left hand usage mount side

Blade install: (Fig. 1)

  1. Determine right hand or left hand usage.
  2. Remove nut and three (3) blades.
  3. Separate and install one blade, sharp edge down.
  4. Slide cover to “safe” when not using and “blade” when ready to use.

Apply dust cover:

  1. Using double sided tape , ATG tape or glue, apply continuous line around back of frame about 1/8” from edge (Fig. 2)

Right hand usage mount side

  1. Cut a piece of Kraft paper (30, 40, or 50 lb available at craft stores) that is larger than overall outside of frame by a minimum of 1”.
  2. Lay paper flat onto table and drop the frame straight down onto the paper with taped side down and artwork side facing up. (Fig. 3)
  3. Using water in a spray bottle, completely dampen Kraft paper evenly. As water dries, the paper will shrink tight. (Fig. 4) NOTE: Use a hairdryer to decrease drying time.
  4. Crease paper along the edges of frames (Fig. 5)
  5. Using trimmer, start beyond edge of a corner, hold on slight angle up against frame edge. Draw trimmer along edge to trim. (Fig. 6)
  6. Repeat for other three sides.

Logan Graphic Products Inc. 1100 Brown Street, Wauconda, IL 60084 1-847-526-5515 1-800-331-6232 www.logangraphic.com

Page 2 of 2 · End of manual

Quick start

  1. Determine right hand or left hand usage.
  2. Remove nut and three (3) blades.
  3. Separate and install one blade, sharp edge down.
  4. Slide cover to “safe” when not using and “blade” when ready to use.