

Page 1 of 2

Text on page 2
Pneumatic Adjustable Height Standing Desk
QTY: 1
QTY: 2
QTY: 2
QTY: 12 1/4”x16mm
QTY: 4 1/4”x55mm
QTY: 1
QTY: 2 M4x12mm
TOOLS PROVIDED
QTY: 2 M4x35mm
QTY: 8 M5x12mm
QTY: 16 for each for 1/4”
Hex wrench
QTY: 8 for each for M5 each
INSTRUCTIONS
Spring washer must be between the washer and the screw.
Back side
MyBinding.com 5500 NE Moore Court Hillsboro, OR 97124 Toll Free: 1-800-944-4573 Local: 503-640-5920
Forward
side
Forward side
WARNING
- Legs contain high pressure. Do not open! Do not heat!
- Small items may present choking hazards - keep out of reach of children under 3 years.
- Only use this desk for its intended purposes.
- Sit and stand at this desk, not on it.
- Follow weight capacity guidelines: stationary 150 lbs, active 30 lbs.
- Ensure all hardware is secured before use; check and tighten hardware every 6 months for best results.
- Do not change or modify the infrastructure of this desk in any way.
- If parts are missing or broken, do not use this desk until they are replaced with authorized parts.
Down
Up
Page 2 of 2 · End of manual
Quick start
- Unpack and count: Lay out the hardware: 12 screws 1/4" x 16mm, 4 screws 1/4" x 55mm, 2 M4x12mm, 2 M4x35mm and 8 M5x12mm. Use the hex wrench provided.
- Find the sides: The drawing marks the back side and forward side of the 56" desk. Keep them in the right direction as you build.
- Fit the washers right: At each screw, the spring washer goes between the washer and the screw.
- Secure everything: Tighten all hardware before first use. Do not alter or modify the desk in any way.
- Handle the legs with care: They hold high pressure. Never open or heat them.
- Use it as intended: Sit and stand at the desk, not on it.
- Respect the load: Stationary 150 lbs, active 30 lbs. Check the hardware again every 6 months.
Frequently asked questions
What is the weight guideline for the Luxor 56 inch teak desk?
Stationary load is 150 lbs and active load is 30 lbs. See page 2.
What if a part is missing or broken?
Do not use the desk until it is replaced with authorized parts. See page 2.
Can I modify the desk?
No. Do not change or modify its infrastructure in any way. See page 2.
Which tool comes with the desk?
A hex wrench is provided as the tool. See page 2.
Is it safe to stand on the desktop?
No. Sit and stand at the desk, not on it. See page 2.
