Luxor LOTM16 Charging Station Instruction Manual, page 1

Page 1 of 3

Luxor LOTM16 Charging Station Instruction Manual, page 2
Text on page 2

Open Charging Assembly Guide

  1. Attach the casters (L & M) to the side frames (A & B) with the lock washer (Q) and acorn nut (P), using the included wrench.

Tools Included:

Tools Needed:

  1. Combine the back panel (C) to the bottom panel (D) with 3 screws (R), using the included hex wrench.
  2. Attach side (B) to panels (C & D) Step 4: Attach side (A) to panels (C & D) with 3 screws (R), using the included with 3 screws (R), using the included hex wrench. hex wrench.

Page 2 of 3

Luxor LOTM16 Charging Station Instruction Manual, page 3
Text on page 3

Step 5: Attach the power tray panels (E & F) to the main unit with 2 screws (S), using a screw driver.

Step 6: Attach the bottom power tray panel (G) with 2 screws (S) from below, using a screw driver. Attach the 2 power strip brackets (T,V,& W) to the panel (G) with a screw driver.

Step 7: Push the power strip (X) into the brackets.

Step 8: Install the power tray back panel (H) with 4 screws (S), using a screw driver.

Step 8: Attach the 32 cable clips (K) to the main unit.

Call Us at

for Orders or Inquiries

  1. Install the 17 plastic dividers (J) to the main unit. You have completed assembly.

Page 3 of 3 · End of manual

Quick start

  1. Attach casters L and M to side frames A and B with lock washers Q and acorn nuts P, using the included wrench.
  2. Join back panel C to bottom panel D with 3 screws R using the included hex wrench, then attach sides B and A to panels C and D with 3 screws R each.
  3. Attach power tray panels E and F with 2 screws S, then the bottom power tray panel G with 2 screws S from below.
  4. Attach the power strip brackets to panel G, push power strip X into the brackets, and install back panel H with 4 screws S.
  5. Attach the 32 cable clips K and install the 17 plastic dividers J to finish.

Frequently asked questions

How many dividers and cable clips come with the LOTM16?

The assembly uses 17 plastic dividers (J) and 32 cable clips (K) (page 3).

What tools do I need?

A wrench and hex wrench are included; you also need a screwdriver for the power tray steps (page 2, page 3).

How is the power strip installed?

Attach the power strip brackets to bottom power tray panel G, push power strip X into the brackets, then close it in with back panel H (page 3).