Page 1 of 2
Text on page 2
Wall-mounted Whiteboard Instructions
Parts List Note: Hardware provided is for drywall installation. If attaching
Note: After assembly, remove the protective film from the board with a utility knife.
Slide tray into grove on bottom of wall board. Snap two horizontal chalk lines at the heights indicated from the floor. If attaching to drywall drill four 1 ⁄ 4 ˝ holes as specified.
to other material fasteners are to be furnished by other.
Insert drywall anchors B into holes then attach brackets A at the bottom with screw C making sure the bracket is in the lowest position.
- - Tape Measure
- - Chalk Line
- - Drill
- - 1/4˝ Drill Bit
Attach brackets A at the top with screw C making sure the bracket is in the highest position. Tighten screw just enough so that the bracket can be tapped down with hammer.
Place white board on lower brackets making sure to center it with middle lower bracket
- Attach bracket to wallboard using screw D starting with the middle lower bracket.
- - Extended Drive Phillips
- - Hammer
Tap the top brackets down so they are touching the top of the board. Attach bracket to wallboard using screw D.
35 1 ⁄ 2 ˝ x 47 1 ⁄ 4 ˝ Board
23 5 ⁄ 16 ˝ x 35 5 ⁄ 16 ˝ Board
Chalk Line 21 5 ⁄ 16 ˝ above the bottom Chalk Line
Chalk Line 33 1 ⁄ 2 ˝ above the bottom Chalk Line
Chalk Line 1˝ above the desired bottom position. Recommended 46 3 ⁄ 8 ˝ from the floor.
Chalk Line 1˝ above the desired bottom position. Recommended 37 1 ⁄ 4 ˝ from floor.
Page 2 of 2 · End of manual
Quick start
- Gather a tape measure, chalk line, drill, 1/4" drill bit, extended Phillips screwdriver and hammer, and slide the tray into the groove on the bottom of the board.
- Snap two horizontal chalk lines on the wall: the bottom line 1" above the desired bottom position (recommended 46 3/8" from the floor) and the top line 21 5/16" above it.
- For drywall, drill four 1/4" holes, insert anchors B and attach the bottom brackets A with screws C in their lowest position.
- Attach the top brackets A with screws C in their highest position, tightened just enough that they can be tapped down with a hammer.
- Set the board on the lower brackets, centered on the middle bracket, and fasten it with screws D starting with the middle lower bracket.
- Tap the top brackets down onto the top of the board and fasten them with screws D.
- After assembly, remove the protective film from the board with a utility knife.
Frequently asked questions
Is mounting hardware included?
Yes, for drywall. If you are mounting to another material, you need to supply your own fasteners (page 2).
What tools do I need to hang the whiteboard?
A tape measure, chalk line, drill with a 1/4" bit, extended Phillips screwdriver and hammer (page 2).
How high should I mount the whiteboard?
Snap the bottom chalk line 1" above the board's desired bottom position. The recommended position is 46 3/8" from the floor (page 2).
How do I remove the protective film?
After assembly, remove the protective film from the board with a utility knife (page 2).
