Martin Yale 7000E 12" Commercial Stack Cutter Instruction Manual, page 1

Page 1 of 5

Martin Yale 7000E 12" Commercial Stack Cutter Instruction Manual, page 2

Page 2 of 5

Martin Yale 7000E 12" Commercial Stack Cutter Instruction Manual, page 3

Page 3 of 5

Martin Yale 7000E 12" Commercial Stack Cutter Instruction Manual, page 4

Page 4 of 5

Martin Yale 7000E 12" Commercial Stack Cutter Instruction Manual, page 5

Page 5 of 5 · End of manual

Quick start

  1. Set up: Place the cutter on a flat, level surface with all four feet touching. Raise the blade handle fully so the safety arm engages.
  2. Raise the clamp: Turn the clamp wheel counter-clockwise to lift the paper clamp.
  3. Set the back gauge: Loosen the locking knob, align the gauge to the measuring scale for the cut you need, and retighten while pressing the gauge down.
  4. Load paper: Put the stack through the cut opening, flush against the side rail and back gauge.
  5. Clamp: Hold the stack and turn the clamp wheel clockwise. Tighten only 1/4 to 1/2 turn past first firm contact.
  6. Cut: Grip the handle, release the safety arm, and lower the handle in one even stroke.
  7. Finish: Return the handle fully up so the safety latch locks. Raise the clamp and remove the cut paper.

Troubleshooting

ProblemLikely causeFix (from the manual)
Paper not completely cutThe cutting stick has worn a groove, or the blade is not level or set to the right depth.Rotate or replace the cutting stick, and check the blade is level and set to the proper cutting depth. Page 2
Excessive pressure needed to finish a cutThe blade is dull.Sharpen or replace the blade. Heavier or abrasive material may need this more often. Page 2
Cut paper is out of squareThe stack is not aligned to the side rail and back gauge, or not clamped correctly.Align the stack to the side rail and back gauge and clamp it correctly. Page 2
Clamp wheel is hard to turnThe wheel needs lubrication.Lubricate it as described in Section 4.1. Page 2
Handle is hard to move up or downThe handle needs lubrication.Lubricate it as described in Section 4.1. Page 2
Blade cuts on one side but not the otherThe blade is not level.Level the blade as described in Section 4.3.2. Page 2
Blade cuts in the center onlyThe cutting stick is bad.Rotate or replace the cutting stick as described in Section 4.4.1. Page 2

Frequently asked questions

How thick a stack can the 7000E cut?

The thickness capacity is 1 1/2 inches of 24# bond paper. See page 2.

How tight should I clamp the stack?

Tighten the clamp wheel 1/4 to 1/2 turn past first firm contact. More pressure can damage the clamp, and that damage is not covered by the 1-year warranty. See page 3.

How often should the blade be sharpened?

On average, after eight cutting hours of 24# bond paper. Heavier or more abrasive material may need it sooner. See page 2.

Can I rotate the cutting stick?

Yes. It can be rotated to all four sides and turned end for end, giving eight surfaces. See page 5.

What cutting accuracy should I expect after squaring?

Cutting accuracy should be within 1/32 inch and squareness within 1/64 inch. See page 5.