Martin Yale Intimus Stackwagon-501 Manual, page 1

Page 1 of 3

Martin Yale Intimus Stackwagon-501 Manual, page 2

Page 2 of 3

Martin Yale Intimus Stackwagon-501 Manual, page 3

Page 3 of 3 · End of manual

Quick start

  1. Unpack: Take out all parts and compare them with the parts list.
  2. Add casters: Turn the base over and bolt casters to the support channels. Put the locking casters in opposite corners.
  3. Fit dividers: Turn the base upright, place the dividers on top with holes lined up, and attach with truss screws and Keps nuts, finger tight only.
  4. Add the cap: Put the divider cap on top and attach it with pan Sems screws, finger tight.
  5. Place ramps: Set four corner ramps in the sections with corners inside the base angle. Then tighten the divider cap screws.
  6. Secure the ramps: Lift two opposite ramps to tighten screws beneath them, put them back, and fasten all four ramps.

Troubleshooting

ProblemLikely causeFix (from the manual)
Wagon tips over when loadedPaper load is not balancedStack paper evenly across the four corners or in two opposite corners. Page 3
Corner ramps do not fitDividers are slightly out of placeMove the dividers around a little to fit. Page 3
Parts seem missingParts were not counted at unpackingCheck everything against the parts list. Page 3
Wrong ramp on the 501The Model 501 uses two left and two right rampsUse the left and right ramps listed for the 501. Page 3
Parts will not line up while assemblingScrews were fully tightened too earlyKeep divider screws finger tight until the cap and ramps are placed. Page 3

Frequently asked questions

How is the 501 different from the 500?

The manual says the 501 is similar to the 500 but 12 inches wider. See page 3.

Where do the locking casters go?

Put the locking casters in opposite corners. See page 3.

How should I load paper on the wagon?

Balance the load between all four corners or two opposite corners to help prevent tipping. See page 3.

Are the corner ramps the same on both models?

On the 500 they are identical. The 501 uses two left and two right ramps. See page 3.

How many casters are in the parts list?

The list shows 2 casters with lock and 2 without lock for both models. See page 3.