

Page 1 of 3

Page 2 of 3

Page 3 of 3 · End of manual
Quick start
- Check parts: Find all loose parts in the box using the parts list and diagram. Fit the door handle with two sets of screws and nuts.
- Build the frame: Bolt the sides to the top and bottom with the smooth faces of the parts pointing inward, then tighten the screws.
- Add clamps and bar: Attach the paper clamps with knobs and washers. Install the elevation bar by placing its leg ends in the second hole at the bottom of each side.
- Tilt and set the door: Turn the elevation bar to tilt the press forward. Seat the door bottom edge in the base plate slot and the top edge over the top plate.
- Load the paper: Jog the sheets first. Square them against the door and put the pressure plate on top of the stack.
- Clamp: Lower the clamps onto the pressure plate and tighten the hand knobs. Use the thumbscrews for more pressure, not tools.
- Pad: Remove the door and apply padding compound to the paper edge. Let it dry, then release the clamps to take out the pad.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| Stack is loose in the press | Clamp pressure is too low | Tighten the hand knobs on the clamps and add pressure with the thumbscrews. Wrenches and pliers should not be used. Page 2 |
| Door will not sit properly | The press is not tilted, or the door is not seated in its slot | Turn the elevation bar to tilt the press forward. Put the door bottom in the base plate slot and its top over the top plate. Page 2 |
| Uneven pad edge | Paper was not jogged before padding | Jog all material first. A Martin Yale Model 400 or 4200 Jogger is recommended. Page 2 |
| Carbonless compound barely enters the sheets | Pressure plate sits at the very edge of the paper | Set the plate back from the edge. For snap-outs in carbonless forms, move it in about 1/4 inch. Page 2 |
| Brush leaves mixed residue | Same brush used for regular and carbonless compounds | Keep one brush for each compound type and use a paper liner to ease cleanup. Page 2 |
Frequently asked questions
What is the elevation bar for on the J1824?
Rotating it tilts the press forward so the door can be set in place. It is installed in the second hole at the bottom of the sides. See page 2.
How do I clean the Jiffy Giant Padding Press?
Use warm, soapy water after each use. A paper liner helps keep cleanup short. See page 2.
Can I tighten the clamps with a wrench?
No. Use the hand knobs and thumbscrews only. See page 2.
How should I pad carbonless paper?
Move the pressure plate away from the paper edge so the compound soaks in further. For snap-outs, about 1/4 inch in works. See page 2.
Is a jogger needed?
It is not required, but jogging all material before padding gives the best results. A Martin Yale Model 400 or 4200 is recommended. See page 2.
