

Page 1 of 5

Page 2 of 5

Page 3 of 5

Page 4 of 5

Page 5 of 5 · End of manual
Quick start
- Keep power off: Do not connect power until you are ready to fold. Keep the outlet close and unblocked, and keep hair, loose clothing and jewelry away from moving parts.
- Set the paper stop: Push in the adjustment knob on the right side, then turn it to the position for your fold type and paper size.
- Connect power: Unwind the wall power supply and push the right end firmly into the connector on the back. Plug it into an outlet.
- Feed paper: Slide up to four sheets into the rear slot until they stop. The folder starts after a short delay, so then let go lightly.
- Mind the staples: Stapled sets are allowed, but the staples must not sit where a fold will fall. The stapled end goes in first.
- Collect the fold: Take folded sheets from the front slot. The machine stops on its own after the cycle.
Troubleshooting
| Problem | Likely cause | Fix (from the manual) |
|---|---|---|
| The folder does not run | Paper jam, loose power connection, or a tripped circuit breaker | Clear any jam, check the wall power supply at the folder and the outlet, and if the breaker tripped, unplug the folder for at least 1 minute so it resets. Page 5 |
| Paper jams during folding | Wrong stop setting, open dejamming door, too many sheets, or dirty rollers | Check the paper stop knob setting, close the dejamming door fully, stay within the sheet capacity, and clean the rollers if needed. Page 5 |
| The folder runs nonstop | The optical sensors may be dirty | Follow steps 1 to 4 of the disassembly instructions, then clean the sensors with a cotton swab and rubbing alcohol, especially the facing curved surfaces. Page 5 |
| Paper is stuck in the folder | A jam inside the mechanism | Unplug the folder, fit the dejamming handle on the D-shaped shaft, and turn it while gently pulling the paper out. Open the dejamming door on the bottom if needed. Page 4 |
| Folds are inaccurate | Paper is held too tightly in the slot | Hold the sheets at the top center, very lightly, so they can square themselves on the folding rollers. Page 3 |
Frequently asked questions
How many sheets can the P6400 fold at once?
Half-fold takes 1 to 4 sheets of 16-20# bond or 1 to 3 sheets of 24# bond. Letter fold takes 1 to 3 sheets of 16-20# bond or 1 to 2 sheets of 24# bond. See page 2.
What fold types does it do?
Half fold and letter fold. It adjusts for 8 1/2 x 11 inch paper and ISO A4. See page 2.
How do I clear a paper jam?
Unplug the folder and use the dejamming handle on the D-shaped shaft to turn the rollers while pulling the paper out. Open the dejamming door on the bottom if the jam is deep. See page 3.
What should I use to clean the rollers?
Use Martin Yale Rubber Roller Cleaner And Rejuvenator on a lint-free cloth. Another cleaner could damage the rollers. See page 4.
Can I fold stapled sheets?
Yes, but keep staples away from the fold locations and feed the stapled end first. See page 3.
