Martin Yale SP100 Score and Perf Machine Manual, page 1

Page 1 of 5

Martin Yale SP100 Score and Perf Machine Manual, page 2

Page 2 of 5

Martin Yale SP100 Score and Perf Machine Manual, page 3

Page 3 of 5

Martin Yale SP100 Score and Perf Machine Manual, page 4

Page 4 of 5

Martin Yale SP100 Score and Perf Machine Manual, page 5

Page 5 of 5 · End of manual

Quick start

  1. Place the unit: Put the machine on a tabletop with the power switch at 0. Keep long hair, jewelry and loose sleeves away from the blades.
  2. Check the retarder: In each feed shelf, make sure the retarder tips do not touch the feed wheels. Contact can damage the wheels.
  3. Remove stack weights: Take the taped accessories off the exit tray shelves before the first run.
  4. Install trays: Fit the paper support by inserting its tabs into the slots on the front of the feed shelf, and add the catch tray.
  5. Set registration: Loosen the paper guide thumb knobs, lift the retarder, and line register marks up with the blade edges. Leave no more than 1/32 inch of side play without pinching the stock.
  6. Test: Turn the rocker switch to 1 and feed single sheets to check accuracy. Readjust the guides as needed.

Troubleshooting

ProblemLikely causeFix (from the manual)
No power when switched onDead outlet or tripped circuit breakerTest the outlet with another device. If it still has no power, find and fix what is binding the machine, let it cool, and push the breaker in to reset it. Page 3
Multiple sheets feed at onceFeed system not set correctlySet the feed pressure arm just above the feed wheel, then adjust the retarder until it gives a slight drag. Test with a neat stack of three sheets. Page 5
Glossy stock will not feed wellFeed wheels have trouble gripping glossy sheetsIf one side is not glossy, run the sheet with the glossy side up. Page 5
Inaccurate registrationRegistration or layout marks are not set properlySet registration as described in the manual and double-check how the register marks on the layout are being used. Page 5
Hesitant feed with raised lettering or curled stockRaised print or curl stops the retarder from working normallyRun the stock image side down, weight it beforehand, or use the top weights on the stack. Call technical support if it persists. Page 5
Accessory screws strippedSetscrews were overtightenedTighten only 1/8 to 1/16 of a turn past snug. Page 5

Frequently asked questions

What paper weights does the SP100 handle?

It handles 24# bond up to 100# cover stock. See page 2.

How fast is the SP100?

The manual lists 1400 sheets per hour. See page 2.

Why is the machine not turning on?

Check the outlet first, then the circuit breaker. If the breaker tripped, fix the cause of the bind, let the unit cool and reset it. See page 3.

How do I move the scoring or perforating wheel?

Loosen the 3/32 inch Allen setscrew in the hub, slide the part into place and retighten. The scoring roller has no setscrew and should spin freely. See page 5.

Do I need to adjust the feed for normal stock?

No. The feed is preset for 65# stock and usually needs no readjustment. See page 5.