Polar Laminating FilmSheets

Uv Laminating Films Coated With Cold Adhesive

Instructions

1. (Figure 1) Peel Back 2" of the cover sheet from one end of the laminating film.
2. (Figure 2) Tack the Laminating film to a Sled or backing board. A Sled is a non-stick board. Insure your Sled is larger than the print you are laminating. Make sure the tacked edge is smooth.

Figure 1

3. Position your print under the laminate film.

4. (Figure 3) Remove the remaining Coversheet on the laminating to expose the adhesive on the film. If using a laminator (shown), insert Figure 2 the tacked edge into the laminator to hold your film and Sled. Make sure the opening between the top and bottom roller matches your sled thick- ness and you have sufficient pressure. Flip the laminate film forward over the top roller (lf you have a Media Guide, insert it between the Me- dia Guide and the Top Roller).

5. (Figure 4) Remove the rest of the Coversheet exposing the adhe- Figure 3 sive on the film. (lf you have a Media Guide Close the Guide)

5. (Figure 5) Roll Down your film. If you are using a laminator, hold your print smooth against the roll (lf you have a Media Guide, insert your print between the Media Guide and top roller and close the Media Guide to hold your print against the roller. Then roll down your print to adhere Figure 4 the film to your print.

Figure 5