QRT-300TE User's Manual, page 1

Page 1 of 3

QRT-300TE User's Manual, page 2

Page 2 of 3

QRT-300TE User's Manual, page 3

Page 3 of 3 · End of manual

Quick start

  1. Check the kit: You need the marker board, 2 uprights, a support bar, a marker tray, 2 board locks, 2 flip chart holders, casters, caps, posts and Allen bolts. Have an open end wrench or pliers and a Phillips screwdriver ready.
  2. Fit the casters: Screw a locking caster into the front hole of each upright. Screw a free wheel caster into the back hole and tighten.
  3. Join the uprights: Bolt each upright to the support bar with a 5/16" x 1" Allen bolt. Use the supplied Allen wrench.
  4. Add the marker tray: Face the tray forward and fix it to both uprights with four Allen bolts.
  5. Fit locks and posts: Slide the board locks over the uprights down to the tray. Then attach a plastic post to each upright with a Phillips screw.
  6. Mount the board: Set the board pivot pins into the keyholes in the uprights. Raise the board until the locks click.
  7. Finish: Press the flat caps into the bolt holes and the radius caps into the rear of the base supports.

Troubleshooting

ProblemLikely causeFix (from the manual)
Board will not rotateThe board locks are holding the board in place.Lower the board locks to the marker tray. The board is then free to rotate. Page 2
Board does not stay upThe board is not lined up with the board locks.Adjust the board to align with the locks and raise it until they click into the locked position. Page 2
Flip chart holders are crooked or in the wrong spotThe holders use adhesive and cannot be moved once stuck to the board.Check that both holders are level and in the place you want before attaching them. Once attached, they cannot be repositioned or removed. Page 2
Plastic posts will not fit properlyThe board locks were not lowered before the posts were installed.Lower the board locks to the marker tray first. Then attach the posts to the pre-drilled holes above the tray. Page 2
Tape or marker marks on the boardTape or permanent marker was used on the board.Do not use tape on the board surface. Do not use permanent marker on the marker board. Page 2

Frequently asked questions

What tools do I need to assemble the QRT-300TE easel?

You need an open end wrench or pliers and a Phillips screwdriver. An Allen wrench comes in the kit. See page 2.

How do I make the board rotate?

Lower the board locks down to the marker tray. This frees the board so it can rotate. See page 2.

Can I use permanent markers or tape on the board?

No. The manual says not to use tape on the board surface or permanent marker on the marker board. See page 2.

Can I move the flip chart holders after they are attached?

No. Once the holders are stuck to the board, they cannot be repositioned or removed. Make sure they are level first. See page 2.

Does the easel have wheels?

Yes. The kit has 2 locking casters for the front and 2 free wheel casters for the back. See page 2.